622638
4
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
PROMIX220U
V. 02 – 09/03/2012 4 ©Velleman nv
Always begin with the master faders, volume controls and the amplifier volume at minimum position.
Gradually turn up the volume after connection is completed.
Use the controls with restraint. Rapid movements may damage the speakers due to amplifier clipping.
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
4. Features
outputs: 2 Master (XLR and RCA), 1 Rec (RCA) and booth monitor output (RCA)
inputs: 1 Phono (RCA), 2 Line (RCA) and 1 MIC (Combi)
trim: gain for each input channel
peak level meter: allows the user to instantly determine the source input condition for each channel
talk over: mutes -14dB all levels apart from the microphone
cross fader curve: choose from two types of cross fader start-up options
headphone monitor balance between cue and master out
gain control with 3-fold sound control (+12/-24dB) per channel
MIC channel 1 with 3-fold sound control (+12/-12dB), gain, cue and talk-over
ultra high-performance headphones output, 1-way equalizer, cue-master-mix.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power switch: turn the mixer on or off.
2 POWER SUPPLY INPUT: connect to 230VAC/50Hz power source
3 Balanced master outputs: audio output signal connectors (XLR, symmetrical)
4 Master RCA output: RCA connection to an auxiliary amplifier (not included)
5 BOOTH: RCA connection for booth monitor (not included)
6 REC: RCA connection to recording device (not included)
7 CONTROL A/B: CD player inputs
8 USB: USB input
9
Input connectors (CH2-CH1): connect an external device (not incl., e.g. turntable, CD player…) to
these RCA (cinch) connectors.
10 GND (ground) connection: when buzzing occurs, connect to turntables to create earth connection.
11 PHONES OUT: plug a headphone into this jack for audio monitoring
12
6.35mm microphone input (microphone not incl.)
MIC LEVEL: adjust the microphone input level
HI/MID/LOW: microphone equalizer
13
Input channel controls (CH1/CH2)
Input selector switches:
Channel 1: LINE or PHONO. Set to PHONO if a turntable (not incl.) is connected to the input;
otherwise set to LINE.
Channel 2: LINE or USB. Set to USB if an input device is connected via the USB port [8]; otherwise
set to LINE.
TRIM: adjust the input signal level
HI/MID/LOW: channel equalizer
14 LED meter: indicates the master output level
15
TALK OVER: press this button to decrease the sound level for everything other than the main
microphone to 14dB. Press again to restore original status.
16
Headphones controls
PHONES LEVEL: adjust the output level of the headphones
CUE: mixing adjustment knob. Turn to the left to hear channel 1. Turn to the right to hear channel 2. At
the centre position, the levels for both channels are even.
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für HQ Power PROMIX220U wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info