Bedienungsanleitung Hwam 5530 - Autopilot (Seite 7 von 8) (Englisch)

744542

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Cleaning

Before chimney sweeping can be performed, the adjustment bar must be set all the way to the left to prevent soot and ash from entering the

HWAM

Autopilot

. Remove the smoke shelf. Push the plate forward and lift it up a bit to the side. Tilt one side downward. The plate is now

free and can be removed from the combustion chamber. Unless the safety ﬁttings for transportation (2 split pins) have not already been removed,

start by removing the split pins. Lift the steel smoke deﬂector plate off of the hooks so that it can be removed.

Insulation

The efﬁcient, but porous insulation of the combustion chamber may, in time, be worn and damaged. Cracks in the insulation are irrelevant to

the efﬁciency of the stove. However, it should be replaced when, due to wear and tear, it has been reduced to less than half its original thickness.

HWAM

Autopilot

On a cold stove, the starting point of the feeler is controlled. The starting point on a cold stove is about 30° above horizontal. It should feel

easy going and bouncy when you push it, no matter if the stove is cold or hot. By rising or falling temperatures it must not move at a bound. The

damper plates must be dry and clean and slide together unhindered. Control bars and slide gates may have to be smeared with WD40 (never oil).

Surface

Usually, it is not necessary to any treatment to the painted surfaces of the wood-burning stove. Any damage to the paint may, however, be remedied

with spray paint, which can be bought from your stove dealer.

Guarantee

The guarantee does not cover damage due to insufﬁcient maintenance!

operaTional problemS

Blackened glass

• The wood is too damp. Only use wood stored for at least 12 months under cover and with a moisture level of 12-18%.

• The doors seals may be not be tight.

• Insufﬁcient secondary air introduced to the pane-ﬂushing system. Push the adjustment bar further to the right until the glass is burned clean.

• Intermittent ﬁring. Allow the stove to heat through properly.

Smoke in the room when opening door

• The damper in the chimney may be closed. Open the damper.

• Insufﬁcient chimney draft. See section on chimney or contact chimney sweep.

• Soot door leaking or dislodged. Replace or reﬁt.

• Never open door when there are still ﬂames in the wood.

Uncontrollable combustion

• A seal in the door is not completely tight. Replace the seal.

• If the draught is too strong inside the chimney, it may be necessary to set the adjustment bar to minimum, i.e. to the left.

If problems occur that you cannot ﬁx yourself, please consult your wood-burning stove dealer.

deClaraTion oF perFormanCe

The DoP can be downloaded from our website via the following link:

HWAM 5530 www.hwam.com/dop/5530

30°

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 5530 - Autopilot Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 5530 - Autopilot

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info