Bedienungsanleitung Icon Image 10.6Q - IETL14070 (Seite 3 von 14) (Englisch)

654650

Zoom out

Zoom in

Vorherige Seite

1/14

Nächste Seite

PART LISTÑModel No. IETL14070 R0399A

Key No. Qty. Description

1 1 Frame

2 38 Screw

3 4 Isolator/Wheel Nut

4 4 Motor Bushing

5 1 Controller Bracket

6 4 Isolator

7 1 Choke Bracket

8 1 14Ó Controller Wire

9 1 6Ó Wire Harness

10* 1 Motor/Pulley/Flywheel/Fan

11 1 Latch Housing

12 1 Left Foot Rail

13 2 Rear Platform Screw

14 2 Roller Guard

15 1 Walking Platform

16 1 Rear Roller

17 1 Incline Pivot Bolt

18 1 Front Roller/Pulley

19 4 Motor Bolt

20 1 Console Base

21 32 Bracket Screw

22 2 Hood Anchor

23 2 Hood Anchor Bracket

24 4 Motor Bracket Bolt

25 2 Motor Bracket Washer

26 3 Long Hood Bracket

27 2 Belt Guide

28 1 Console Warning Decal

29 1 Outlet Bracket

30 1 Circuit Breaker

31 1 Receptacle

32 2 Grommet

33 1 On/Off Switch

34 1 Incline Leg

35 1 Front Roller Adj. Bolt

36 5 Roller Adj. Washer

37 2 Incline Leg Spacer

38 4 Incline Leg Pivot Nut

39 4 Motor Nut

40 1 Motor Pivot Bolt

41 3 Frame Pivot/Incline Bolt

42 1 Key/Clip

43 2 Flange Nut

44 1 Motor Tension Nut

45 2 Small Nut

46 8 Wheel Washer

47 2 Small Bolt

48 1 Sensor

49 1 Speed Sensor Bracket

50 1 Speed Disk

51 1 20Ó Wire Harness

52 1 4Ó Wire Tie

53 1 Battery Cover

Key No. Qty. Description

54 2 Shock

55 1 Walking Belt

56 8 Belly Pan Spacer

57 1 Choke

58 3 Hood Anchor Screw

59 1 Belly Pan

60 1 Right Foot Rail

61 5 8Ó Cable Tie

62 1 Motor Bracket

63 1 Tie Holder

64 1 Releasable tie

65 2 Rear Roller Adj. Bolt

66 1 Rear Roller Endcap

67 2 Endcap Pad

68 1 Pulse Monitor

69 1 Monitor Strap

70 1 Console

71 5 Side Bracket Screw

72 1 Motor

73 4 Upright Cap

74 4 Console/Hood Side Screw

75 1 Console Plate

76 1 Electronic Bracket Guard

77 1 Hood

78 5 Console Back/Hood Screw

79 20 Foot Rail Washer

80 1 Power Board

81 4 Plastic Stand-Off

82 2 Motor Tension Washer

83 1 Controller

84 1 Upright Wire Harness

85 1 Filter

86 1 Electronics Plate

87 1 Upright Cover (right inside)

88 2 Upright Cover

89 4 Platform Screw (front)

90 2 Wheel Bolt

91 4 Front Wheel

92 1 Motor Belt

93 4 Pivot Nut

94 1 Adhesive Clip

95 1 Allen Wrench

96 2 Upright Cap

97 2 Handrail Foam

98 2 Handrail Endcap

99 1 Lock Knob

100 1 Lock Knob Sleeve

101 1 Lock Knob Spring

102 1 Lock Pin Collar

103 1 Lock Pin

104 1 Pin Clip

105 4 Platform Washer

Note: To identify the parts listed below, refer to the EXPLODED DRAWING attached at the centre of this manual.

14. Never start the treadmill whilst you are stand-

ing on the walking belt. Always hold the

handrails whilst exercising on the treadmill.

15. The treadmill is capable of high speeds.

Adjust the speed in small increments to avoid

sudden jumps in speed.

16. The heart rate monitor is not a medical de-

vice. Various factors, including the user's

movement, may affect the accuracy of heart

rate readings. The heart rate monitor is in-

tended only as an exercise aid in determining

heart rate trends in general.

17. Never leave the treadmill unattended whilst it

is running. Always remove the key and move

the on/off switch to the ÒoffÓ position when

the treadmill is not in use. (See the drawing on

page 4 for the location of the on/off switch.)

18. Do not attempt to raise, lower, or move the

treadmill until it is properly assembled. (See

ASSEMBLY on page 5, and HOW TO MOVE

THE TREADMILL on page 17.) You must be

able to safely lift 45 pounds (20 kg) in order

to raise, lower, or move the treadmill.

19. When folding or moving the treadmill, make

sure that the storage latch is fully closed.

20. Inspect and tighten all parts of the treadmill

every three months.

21. Never insert any object into any opening.

22. The roller guards must be 1/8 inch (3mm)

from the rear roller. Remove the key and ad-

just the roller guards, if necessary.

23. Always unplug the power cord before per-

forming the maintenance and adjustment pro-

cedures described in this manual. Never re-

move the motor hood unless instructed to do

so by an authorised service representative.

Servicing other than the procedures in this

manual should be performed by an authorised

service representative only.

SAVE THESE INSTRUCTIONS

WARNING: Before beginning this or any exercise program, consult your physician. This

is especially important for persons over the age of 35 or persons with pre-existing health problems.

Read all instructions before using. ICON assumes no responsibility for personal injury or property

damage sustained by or through the use of this product.

The decals shown below have been placed on the treadmill. If a decal is missing, or if it is not legible,

please call our Customer Service Department to order a free replacement decal (see ORDERING RE-

PLACEMENT PARTS on back cover). Apply the decal in the location shown.

IMPORTANT: Incline must be set at

lowest level before

folding treadmill into

storage position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Icon Image 10.6Q - IETL14070 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Icon Image 10.6Q - IETL14070

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info