Bedienungsanleitung Ignis AWP 095 (Seite 2 von 2) (Englisch)

75775

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Add detergents as indicated on the front page

and as described in the chapter “Detergent and

Additives” in your Instructions for Use.

• Turn the programme selector to the desired

programme and temperature.

• The indication lamp next to “Start/Pause”

button blinks.

CONSUMPTION DATA

ADD DETERGENTS, CLOSE THE DOOR

AND SELECT THE PROGRAMME

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the

lamp lights to show the the door can be opened.

As long as a wash programme is running, the door

remains locked and must on no account be forced

open. In case you have an urgent need to open

it during a running programme, refer to “Cancel

(Reset) a running programme before the end”.

FAILURE INDICATIONS

In case of any failures or irregularities, consult the

“Troubleshooting Guide” in your Instructions for

Use.

“Service”

Lighting up of the “Service” indication can be

caused by a fault in an electrical component.

“Water tap closed”

The washing machine has no or insufficient water

supply; the water tap might be closed or the water

inlet hose kinked.

“Clean pump”

Waste water is not pumped out. The drain hose

may be kinked or the filter must be cleaned (see

“Cleaning the filter” in your Instructions for Use).

“Rinse hold” button

• The laundry remains in the last rinse water

without pregressing to the final spin cycle to

avoid creasing and prevent colours from

changing.

• This option is particularly recommended for the

programmes “Synthetics” and “Delicates”.

• It is particularly useful if you want to postpone

spinning to a later time, or if you want to drain

only.

• If you select “Rinse hold” do not leave items to

soak for too long.

Note: The programme stops to “Rinse hold” at

the time the “Rinse hold” lights in the

preogramme sequence indication is on. The

indication lamp next to the “Start/Pause”

button flashes.

Terminate the “Rinse hold” option:

• Press the “Start/Pause” button; the

programme will terminate automatically with

the final spin cycle for the present wash

programme.

• If you do not wish to spin the clothes, turn the

programme selector knob to the “Drain”

programme

and press the “Start/Pause”

button.

PROGRAMME START

Open the tap and press the “Start/Pause”

button. The indication lamp next to the “Start/

Pause” button lights up. The programme

sequence indicator shows the current programme

phase, running from left to right through Wash,

Rinse, Spin/Drain.

When the programme phrase is finised, the

corresponding indication goes out.

PROGRAMME END

• All the lights of the programme sequence

indicator are off, and the “Door open”

indication lights up.

1. Turn the programme selector to the “Off/O”

position.

2. Close the water tap.

3. Open the door and unload the machine.

4. Leave the door ajar to allow the drum to dry.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

1. Press the “Start/Pause” button to pause

the programme. The light blinks.

2. Select the new programme (with

temperature), any options and another spin

speed if you want.

3. Press the “Start/Pause” button again.

The new programme continues at the same

position where the previous programme

was interrupted. Do not add detergent for

this programme.

CANCEL (RESET) A RUNNING PROGRAMME

BEFORE THE END

The “Reset” button cancels a programme before

the end.

• Press and hold the “Reset” button for a few

seconds. Any existing water is drained out.

It may last some time until the door can be

opened.

SELECT ANY DESIRED OPTION

Push the button(s) of any option(s) desired - the

respective indication lamp lights up.

When the combination of programme and

additional option(s) is not possible, the indication

lights switch off automatically. Unsuitable

combinations of options are deselected

automatically.

“Spin speed reduction” button

• Reduces the predermined automatic

maximum spin speed to treat your laundry

more gently.

Programme

Temperature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)

Cotton 95 5.0 53 * 1.70 2:00

Cotton ** 60 5.0 44 0.75 4 :00

Cotton **

2.5 32

0.65 2:20

Cotton 40 5.0 49 0.60 2:45

Cotton ** 40 2.5 32 0.55 2:30

Cotton Rapid

5.0 44

0.85 2:30

Synthetics 60 2.5 50 * 0.70 1:30

Synthetics 40 2.5 45 0.50 1:15

Delicates 30

1.5 50

0.50

0:45

Quick wash 30 3.0 40 0.40 0:30

Wool 40 1.0 55 0.60 0:45

Handwash 40 1.0 45 0.60 0:40

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the

home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type

of wash.Water and energy consumption refer to the default setting of the programmes; selecting special options or modifying spin

speed or temperature will change the consumption data.

The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that

time (see also “Troubleshooting Guide” in your Instructions for Use).

To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

** Reference programmes for Energy Label.

Ignis is a registered trademark of Whirlpool USA.

5019 501 01014

Ignis AWP 095 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ignis AWP 095

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info