Bedienungsanleitung Ignis awv 808 (Seite 2 von 2) (Englisch)

305679

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 100 01058

Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy

consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual

consumption may vary in comparison with the values specified in the table, because of differences in supply water

pressure and temperature, the load and the type of wash.

ADDING DETERGENT AND ADDITIVES

Pour the detergent and additives into the respective

compartments as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and starch

• Bleach

• Stain removers

• Anti-scale agents (water hardness 4)

Important Note:

• Do not fill beyond the “

MAX”

level mark.

• For programme with prewash: do not use liquid

detergent.

• For programmes without prewash from cold to 40° C, it is recommended to use a liquid

detergent to avoid whitish residues on the coloured laundry.

CLOSE THE DOOR AND SELECT THE PROGRAMME

1. Turn the

programme selector knob

clockwise to the desired programme.

2. Turn the

temperature knob

to the required temperature.

3. Turn the

spin speed knob

to the required spin speed.

PRESS ANY DESIRED OPTION BUTTON(S)

“Eco” button

• The wash time is extended and the water temperature is reduced.

• This function saves about 30% in energy without compromising the excellent results of

the wash.

“Intensive Rinse” button

• The water level increases for improved rinsing efficiency.

• This option is particularly suitable for areas with very soft water when washing baby

linen and helps people with allergies.

• For improved garment care it is advised to use the option for the Cotton 90° C and the

Coloured 60 °C programme.

“Half Load” button

• Reduces the water consumption in the “Cotton” and “Synthetics” programmes

especially during the rinse.

• Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).

• Not suitable for high temperature programmes.

“Rinse Hold” button

• The laundry remains in the last rinse water, without progressing to the spin cycle to

avoid creasing and prevent colours from changing.

• This option is especially recommended for the “Synthetics” or “Delicate” programmes.

• This option is perfectly suitable if you wish to postpone the spin or you don’t wish to

spin the clothes.

Note:

the programme selector stops on .

Terminate the “Rinse Hold” option

• Press the “Rinse Hold” button again; the programme will terminate automatically with

the spin cycle corresponding to the previously selected wash programme.

• If you do not wish to spin the clothes, switch off the appliance by pressing the “On/Off”

button. The pilot light goes out. Turn the programme selector to the “Drain” position and

switch on the appliance.

PROGRAMME START

Open the water inlet tap and press the “On/Off” button. The pilot lamp lights up.

DOOR LOCK

During the running programme, the door cannot be opened.

The door locks automatically in all programmes.

If the programme is stopped or if an electrical power failure occurs, the door unlocks

automatically after about 1 minute.

PROGRAMME END

• The programme selector knob is at “STOP”.

1. Press the “On/Off” button. The pilot light goes out.

2. Cancel the options by pressing the appropriate buttons.

3. Turn the water supply tap off.

4. Wait for the door to unlock (about 1 minute).

5. Open the door and the drum flaps and unload the machine.

SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER

PROGRAMME START

1. Press the “On/Off” button to switch off the appliance.

The pilot light goes out.

2. Select the new programme, temperature, spin speed and options.

3. Press the “On/Off” button to switch on the appliance.

The pilot light lights.

TO STOP, RESET A PROGRAMME BEFORE THE END

1. Press the “On/Off” button to switch off the appliance.

The pilot light goes out.

2. Set the programme selector on “Drain”.

3. Press the “On/Off” button to start the “Drain” programme.

Only open the door when the programme selector is at “STOP” and

the door is unlocked (after approximately 1 minute).

ENERGY AND WATER CONSUMPTION DATA

Programme Temperature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Programme

time

(min)

Cotton + Intensive Rinse 90 5.0 72 1.80 115

Cotton 60 5.0 66 1.15 115

Coloured + Intensive Rinse 60 2.0 66 0.80 100

Coloured 40 2.0 60 0.40 100

Rapid + 1/2 Load 40 2.5 54 0.50 85

Synthetics + 1/2 Load 30 1.0 54 0.30 70

Delicate 40 1.5 70 0.65 55

Wool 40 1.0 70 0.55 45

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ignis awv 808 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ignis awv 808

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info