9
MAINTENANCE AND CLEANING
Switch-off the appliance before cleaning.
Do not clean the hob if the glass is too hot: risk of burn.
• Remove light marks with a damp cloth with washing up liquid diluted in a little water.
Then rinse with cold water and dry the surface thoroughly.
• Highly corrosive or abrasive detergents and cleaning equipment likely to cause
scratches must be absolutely avoided.
• Do not ever use any steam-driven or pressure appliance.
• Do not use any object that may scratch the ceramic glass.
• Ensure that the pan is dry and clean. Ensure that there are no grains of dust on your
ceramic hob or on the pan. Sliding rough saucepans will scratch the surface.
• Spillages of sugar, jam, jelly, etc. must be removed immediately. You will thus prevent
the surface being damaged.
ENVIRONMENT PRESERVATION
• The packaging material is ecological and can be recycled.
• The worn appliances contain certain noble metals. Apply to the local government
about the possibilities of recycling.
INSTALLATION INSTRUCTIONS
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
Fitting - installing
• The cut out sizes are: 570 x 502 mm
• The piece of furniture or the support in which the hob is to be fitted, as well as the
edges of furniture, the laminate coatings and the glue used to fix them, must be able to
resist temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
• The hobs are classified as “Y” class for heat protection. Ideally the hob should be
installed with plenty of space on either side. There may be a wall at the rear and tall
units or a wall at one side. On the other side, however, no unit or divider must stand
higher than the hob.
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• Materials which are often used to make worktops expand on contact with water. To
protect the cut out edge, apply a coat of varnish or special sealant. Particular care must
be given to applying the adhesive joint supplied with the hob to prevent any leakage
into the supporting furniture. This gasket guaranties a correct seal when used in
conjunction with smooth work top surfaces.
• Not to install the hob to the top of a not ventilated oven or a dishwasher.
