Bedienungsanleitung Intex 28453 Pure Spa SJB-HS-10-1 (Seite 7 von 26) (Englisch)

686125

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

264

S AVE THESE INSTRUCTIONS

(264PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 10/19/2016

English

Page 7

PRODUCT SPECIFICATIONS

SET UP

Cord-connected spa with pump, heater, water jet, blower, control panel, built-in hard water treatment, and

sanitation system.

This product requires a minimum of 13 Amps. If the circuit breaker trips, please check that no other

appliances or other large loads are on the same circuit as the spa.

Site preparation and requirements

• The spa can be installed indoor or outdoor. For household use only.

• The spa must be setup on a level, ﬂ at and smooth surface that is capable of supporting the maximum load

of the ﬁ lled spa with four adult occupants: weight 2500 lbs (1136 kg); six adults: 3500 lbs (1592 kg).

• Make sure the area is free of sharp objects under or around the spa.

• Provide adequate drainage system around the spa to deal with overﬂ ow water and splashes.

• Provide a properly located power outlet to connect the spa and allow easy access for periodic testing of the

cord mounted GFCI/RCD.

• Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance

and/or service.

• The area shall facilitate draining purposes during long term spa storage.

Additional requirements for indoor installation

• Make sure the ﬂ oor can support the full weight of the ﬁ lled spa with the maximum number of occupants.

Check with a qualiﬁ ed contractor or a structural engineer to verify this requirement.

• Make sure the ﬂ oor is water resistant and non-slip surface. Do not install the spa on carpet or other

materials that will be damaged by moisture, condensation.

• Do not install the spa indoors on a second ﬂ oor above ﬁ nished living space due to the possibility of water

and humidity damage.

• Humidity is a natural side effect of indoor spa installation. The room shall be properly ventilated to allow

moisture to escape. Install a ventilating system to prevent excess condensation, moisture in the room.

Additional requirements for outdoor installation

• Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,

lighting, and other safety requirements. Contact your local building code enforcement ofﬁ ce for further

details.

• Make sure the surface is level, ﬂ at, smooth and strong enough to support the full weight of the ﬁ lled spa.

• Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and damage

the spa ﬂ oor.

• Do not expose the spa to direct sunlight for extended period of time.

• It is possible to install and leave the spa outside at a temperature not lower than 39°F (4°C) provided the

water temperature inside the spa is higher than 39°F (4°C) and the water inside the circulation system,

pump, pipe are not frozen. Put a “temp barrier mat” between the spa ﬂ oor and the ground to prevent heat

loss from the bottom of the spa and to provide better heat retention.

Maximum seating capacity: 4 adults 6 adults

Water capacity: 210 gal (795 L) 290 gal (1098 L)

Inner/outer diameter: 59/79 in (150/201 cm) 66/86 in (168/218 cm)

Height: 28 in (71 cm)

Jet pump: 0.9 HP / 120 V / 60 Hz 0.95 HP / 120 V / 60 Hz

Bubble air blower: 1.1 HP / 110-120 V / 60 Hz

Filter pump ﬂ ow rate: 460 gal/hr (1,741 L/hr)

Heater power: 1,300 Watts / 110-120 V / 60 Hz

Temperature range: 68ºF – 104ºF (20ºC – 40ºC)

Temperature rise: 2-3ºF/hr (1-1.5ºC/hr) 1-2ºF/hr (0.5-1ºC/hr)

Number of Water Jet Nozzles: 4 6

Number of Bubble Jets: 120 140

Spa tub recommended working air pressure: 0.083 bar (1.2 psi)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Intex 28453 Pure Spa SJB-HS-10-1 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info