686126
23
Zoom out
Zoom in
Vorherige Seite
1/26
Nächste Seite
264
PO
S AVE THESE INSTRUCTIONS
(264PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 10/19/2016
English
TROUBLESHOOTING
Page 23
PROBLEM CAUSE SOLUTION
NO DISPLAY/SPA
CONTROL UNIT
DOES NOT WORK
Spa is unplugged or off.
Control panel cable plug loose.
• Power failure.
• GFCI/RCD tripped.
• GFCI/RCD broken.
Ensure the spa is plugged and switched on.
Ensure the control panel cable plug is rmly
attached to the control base receptacle.
Check power source.
Reset the GFCI/RCD.
Contact Intex Service Center.
HOUSEHOLD
CIRCUIT BREAKER
TRIPPED
Circuit breaker under rated.
Overloaded circuit breaker.
An electrical fault in the line.
Ensure correct circuit breaker rating.
Provide a dedicated circuit breaker feeding the
spa electrical outlet only.
Contact a qualify electrician to correct the
electrical fault.
NOT HEATING
PROPERLY
Temperature set too low.
• Dirty lter cartridge.
Water temperature decreasing during
heater STANDBY mode.
Heating element failed.
Increase the temperature and attach the spa
cover.
Clean or replace the lter cartridge in time.
If heater is in STANDBY mode, press the ame
button twice to heat up the water to the set
temperature.
Contact Intex Service Center.
JET FUNCTION
DOES NOT WORK
Jet pump is too hot. Turn off and unplug the spa. Let it cool down and
restart all over again.
If problem persists contact Intex Service Center.
JET OUTPUT IS
WEAK
Low water level.
Obstruction in the suction inlet inside
the tub.
Jet nozzles clogged or dirty.
Jet nozzles plumbing pipes damaged.
Add water between MIN and MAX level.
Ensure suction inlet is not covered or blocked.
Clean any dirt inside the jet nozzles.
Contact Intex Service Center.
JET AIR CONTROL
KNOB NOT
WORKING
Jet nozzles clogged or dirty.
• Jet air ow plumbing inside the spa tub
damaged.
Clean any dirt inside the jet nozzles.
Contact Intex Service Center.
FILTRATION PUMP
NOT WORKING
• Dirty lter cartridge.
Filtration inlet and/or outlet clogged.
Filter pump motor failed.
Clean or replace the lter cartridge in time.
Check and clean ltration inlet and outlet
regularly.
Contact Intex Service Center.
WATER NOT CLEAN Cartridge assembly not properly
attached.
• Insuf cient ltering time.
• Dirty lter cartridge.
Improper water maintenance.
Filtration inlet and outlet clogged.
Ensure the cartridge assembly is properly
attached.
• Increase ltration time.
Clean or replace the lter cartridge in time.
Keep the spa water properly sanitized. Refer to
the chemical manufacturer’s instructions.
Check and clean ltration inlet and outlet
regularly.
PUMP
CONNECTORS ARE
NOT LEVEL WITH
THE SPA
CONNECTORS
One characteristic of PVC is that it
changes shape, which is normal.
Elevate the pump with wood or another type of
insulated material to bring the pump’s connectors
level with the spa’s connectors.
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Intex 28453 Pure Spa SJB-HS-11 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info