686609
7
Zoom out
Zoom in
Vorherige Seite
1/23
Nächste Seite
342A
SAVE THESE INSTRUCTIONS
(342IO) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/11/2018
English
Page 7
POOL INLET - NOZZLE & PLUNGER VALVE SETUP (optional)
5
2
1
7
1
2
8
INSIDE
LINER WALL
9
WATER
FLOW
POOL
6
25
42
27
INSIDE LINER
WALL
24
41
1.
In a counter-clockwise motion unscrew plunger valve
union from the inlet threaded air connector
(42)
(see
drawing 5)
. Be careful not to lose the step rubber
washer
(23)
. Place the plunger valve on the ground in
a safe place.
2.
In a counter-clockwise motion unscrew the strainer
nut
(24)
from the inlet threaded air connector
(42)
.
Leave the flat washer
(25)
on the connector
(42)
.
3.
Install the nozzle and plunger valve at the upper
position of pool inlet.
From the inside of the pool liner
insert the nozzle union
(27 & 42)
into one of the
pre-cut holes with the washer remaining on the
connector to be placed against the inside of the liner
wall.
4.
Before assembly, lubricate the threads with a
petroleum jelly. Then, with the flat side of the
strainer nut
(24)
facing the outside wall of the liner
in a clockwise motion screw the strainer nut
(24)
back onto the inlet threaded air connector
(42) (see
drawing 6)
.
5.
Finger tighten the adjustable pool inlet jet nozzle
(27)
and the strainer nut
(24)
onto the inlet threaded air
connector
(42)
.
6.
Grasp the plunger valve assembly. Make sure the
step washer
(23)
is in place.
7.
Screw the air jet valve
(41)
over the inlet threaded air
connector
(42)
.
NOTE:
Make sure the air jet valve
is securely tighten and facing up. In a clockwise
motion screw the plunger valve union back onto the
inlet threaded air connector
(42) (see drawing 7)
.
8.
In a clockwise motion turn the plunger valve handle
to close position. Ensure the plunger valve is securely
closed. This will prevent water from flowing out during
filling of the pool
(see drawing 8)
.
9.
Adjust the direction of nozzle head pointing away
from the pool outlet for a better circulation result
(see drawing 9)
.
10.
The pool liner is now ready to fill with water. Consult
the above-ground-pool owner’s manual for filling
instructions.
7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Intex SF60220-2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Intex SF60220-2

Intex SF60220-2 Bedienungsanleitung - Deutsch - 23 seiten

Intex SF60220-2 Bedienungsanleitung - Französisch - 24 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info