Bedienungsanleitung Irox JKT-3R (Seite 2 von 4) (Englisch, Italienisch)

578869

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Start search process for a sensor

Select the desired radio channel with the CHANNEL key.

Example: Channel 4 (the number 4 is flashing)

Now press and hold the SEARCH key until the wave symbol starts to flash. The device now

searches for the sensor on channel no. 4. This process can take a few minutes and is finished

as soon as the wave symbol stops flashing.

We have deliberately ensured that the search channel can be individually called up per channel

so that sensors that are already logged in are not affected by subsequent enhancements.

Signal interruptions

Each sensor is read by the device once a minute. If more than 8 readings are read one after the

other without data, lines appear in the display for this channel and the JKT-3R then stops any

other reception attempts after this for 8 hours.

The display device starts a reception again by itself after approx. 8 hours. If the original sender

is not found again, the device starts with a new search for a new sensor on this channel.

When the signal is interrupted, you can start a new signal search at any time manually. Please,

however,check the following points beforehand:

1. whether the sensor is still in place

2. the batteries of the sensor and the display device. Please also replace them when a battery

tester rates them as still being sufficient! Further info on this can be found in the FAQ on

www.irox.com.

Note: If the outdoor temperature drops sharply, the output of batteries that have been started

is also strongly reduced. It is therefore recommended that new batteries are always inserted

in the sensor at the beginning of the winter (alkaline type or better).

3. whether disturbances or shields are to be found in the area of the sender/receiver or the

distance between the two devices is too great.

The search processes described above for a ‘lost’ sensor do not have any influence on any

other existing sensors that function without problems.

Signal ‘collisions’

Radio signals of other devices in their environment can cause disruptions or temporary

interruptions in reception. This is not bad but could be annoying under certain circumstances.

Such typical 'disruptive systems’ are radio door bells, wireless security systems, tube screens

(PC/TV), control systems, etc. In such cases, it can also be helpful to use another channel.

5. OPERATION

The JKT-3R measures the temperature directly and also receives the measurements of up to

a maximum of 5 IROX radio temperature sensors. Each sensor is to be set to one of the

channels 1-5 (resp.1-3 for 3-channel devices). The temperature currently measured is

displayed in the information windows in °C (or °F).

The following operations can be made in this function:

5.1 THERMOMETER

5.1.1 Reading of the temperature from each channel

CH1 CH2 CH3

CH4 CH5 CH1 etc

Briefly confirm the key CH to jump from channel to channel.

- The next channel is thus displayed with each press of the key and activated for further

operations. The sequence of the activation is

This is independent of whether a radio sensor is available in the system or not.

Please note: The measurement is always depicted in the lower window; channels 1-5 one

after the other in the upper window.

5.1.2 MIN/MAX memory

a) The MIN/MAX values are always present on the display below the current measurement value.

- LEFT: Minimal (=lowest) temperature "MIN"

- RIGHT: Maximum (=highest) temperature "MAX"

The logic of the recordings is displayed in Section 2.2 Operating elements.

Please note: Lines appear if no data are available. This occurs when a channel is not allocated

or the sensor is no longer being received.

6. CHANGE OF BATTERY

: BATTERY CHANGE DISPLAY

The batteries last for around 8-12 months. Depending on the usage of the appliance and the

batteries used, this time can be slightly shorter or longer. In order to avoid a surprising and

unpleasant interruption to operations, the battery symbol appears in the two temperature

windows with the corresponding channel. This means that batteries of the display appliance (in

the IN window) or of a radio sender (in the CHx window) are becoming too weak and need to be

replaced.

To change the batteries, please note Chapter 3 (Putting into operation).

Please only use new batteries and never mix old and new batteries.

Please also remember that used batteries should not be thrown in the household rubbish bin

but handed in at the designated collection points. The environment will thank you for it!

7. CARE INSTRUCTIONS

- Do not expose the device to extreme temperatures or direct sunlight over longer periods.

- Avoid blows and shocks of any kind to the device.

- For cleaning use a dry soft cloth that you have moistened with water and a mild cleaning agent.

Never use volatile substances such as benzene, thinner, cleansing agents in spray cans etc.

- When the device is not being used store it in a dry area and out of the reach of small children.

- If the device is activated under extreme coldness it may occur that the display becomes

illegible. As soon as it is returned to a warm environment the device will function normally.

- Please keep the user’s manual and other documents delivered with the device stored carefully

so that you can reference them at a later point if necessary.

- Please use only new batteries and never mix old and new batteries.

- Please also remember that old batteries should not be disposed of with household waste but

should be handed in at the designated collection centres.

- Important: With all Irox appliances, all disposal fees in Switzerland (vRG; advance recycling

fee) and in the EU (WEEE) have been paid.

8. SUPPORT

This device is a new development of Irox Development Technology. All information was made

and checked by means of a functioning instrument. It may occur that adjustments and

improvements of the device will take place that due to typographical procedures were not able

to be listed in this manual. Should you notice deviations which make it difficult for you to

operate and use the instrument you may at any time download the latest manual onto your PC

free of charge at www.irox.com (please refer to the version number of the manual).

3635

3837

1413

1615 2827

Irox JKT-3R Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Irox JKT-3R

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info