554993
6
Zoom out
Zoom in
Vorherige Seite
1/9
Nächste Seite
2322
ENEN
MZZ56200MZZ56200
INSTALLING THE CAMERA
1. Carefully unpack the camera and remove the foil on IR LED cover.
2. Mount the camera on a wall
Mark the position of the screw holes on the wall, drill the holes and
screw 2 screws into them, then rmly attach the camera to the
wall by placing the stand over the installed screws and pushing the
base downwards.
NOTE: The camera can also be simply placed on a flat surface
without any special installation needed.
3. Adjust the camera to monitor the requested area.
CONNECTING THE CAMERA TO THE POWER
The camera can be powered either by the provided power adaptor or using the included rechargeable
accumulator (or 4 AA batteries, not included).
NOTE: If you plan to permanently mount the camera on a wall location, it is recommended to use the
included camera power adaptor to prevent interruptions to the image, as using battery power is only
intended as a temporary power solution.
Power Adaptor
Connect the power adaptor to the camera. Make sure the power adaptor is plugged into an outlet.
Rechargeable Accumulator
1. Remove the battery cover from the
base of the camera.
2. Insert the included rechargeable
accumulator into the battery
compartment. Make sure to
correctly line up the positive (+)
and negative (-) terminals of the
accumulator.
3. Put the battery cover back on.
NOTE: If the camera is connected to
the AC adaptor, the batteries will not
be used, although the accumulator
would be recharged. The accumulator
is intended for short term usage
only.
Connect the 9V adaptor to the Power
Input on the back side of the camera
VIEWING MODE
1. Signal Indicator –shows the strength of the signal being received from the camera. The number of
bars in the signal indicator shows the strength of the signal.
Signal Strength Indicator Warning
Perfect None
Good Nove
Fair Low Signal
Low Low Signal
No Signal No Signal
2. Channel Indicator – Displays the current channel
number. Press the RIGHT arrow on the receiver
to switch between available cameras.
Note: This option is not available for the Tiny mo-
nitor.
LOW SIGNAL AND NO SIGNAL WARNINGS
When the receiver is positioned too far from the camera, the following warning messages are displayed:
LOW SIGNAL: The "LOW SIGNAL" appears
when the receiver has one or two bars. You will
still get an image, however updating may be
less frequent.
NO SIGNAL: The "NO SIGNAL" message
means the receiver cannot access the camera.
Please reposition the camera, or check the
camera power.
Position the base holes over the
screws. Slide the base down to lock
the base in place.
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Jablotron CMD6129S Tiny wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info