631261
14
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
JA-80Y user manual MFJ55800
14
yyy is the minimum acceptable credit balance
zz is the textual position in which the number showing the balance starts in
the reply message from the GSM provider
_ is a space character
The communicator interrogates the GSM network every xx
th
day. The reply message is
scanned for a number – the reported credit balance, with the scan starting at the zz
position. If the number is lower than yyy, the credit balance message from the provider
will be forwarded to phone numbers M1 and M8 to remind someone to top up the SIM
card. If, in addition, event 22 is programmed to be reported to any tel. numbers (M1 to
M8) then the credit balance being under the yyy limit will be indicated by sending the
message “Discharged battery of the communicator” to these numbers. Topping up the SIM
card (so that yyy is exceeded) is indicated by sending the message “Battery OK GSM
communicator”. You can disable automatic credit interrogation by sending the single-shot
instruction xxxx_CREDIT_uu..u.
Example: Sending 4321 CREDIT 101# 7 200 1 will cause the credit balance to be
checked every seventh day (counting from the day of sending) so that a minimum of 200
is requested and the numeric value of the balance is supposed to have its textual position at
the first character in the reply message from the GSM provider.
Notes:
The user is responsible for the credit balance being sufficient!
As a rule, there is a time-limit after which the credit validity will expire!
Owing to the above facts, using pre-paid SIM cards is
not recommended.
Simulated phone line configuration
The communicator is equipped with a phone line connector which allows you to attach a
standard phone with tone dialling. This will make the communicator work as a GSM
gateway, enabling you to perform phone calls. If, in addition, the telephone set allows for
receiving or sending SMS messages (standard: PSTN, FSK V.23, ETSI Protocol 1) then
this function will be provided by the communicator too.
20. Attached phone function sequence 951x
Entering the following instruction on the system keypad allows you to pre-program the
simulated line function (the control panel must be in Maintenance Mode):
951x
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Jablotron JA-80Y - GSM communicator wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Jablotron JA-80Y - GSM communicator

Jablotron JA-80Y - GSM communicator Installationsanweisung - Englisch - 12 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info