698989
5
Zoom out
Zoom in
Vorherige Seite
1/157
Nächste Seite
EN 5
D – WATER & DUST PROOF
The smart folks who made this speaker designed it to
keep the party going through just about anything (they
call it IP67). This means that Zero Chill is dust proof, and
submersible in water up to 1 meter (3ft) for 30 minutes.
But those designers aren’t miracle workers. Doing
something like dropping your speaker from Mount Everest
or taking it deep-sea diving will damage your speaker and
prevent it from emitting the incredible sounds it is made
to. Always keep the side and bottom aps ush with the
speaker when you are using it near water, or it could be
damaged.
E – CALL HANDLING
While rocking out to your music, if a call comes in, short
press the “play/pause” button to pick it up; short press
again when you’re done, to hang up.
While on a call, if you want to make it private, long press
the “play/pause” button to move the call from the speaker
to your phone.
If a call comes in and you don’t want to pick it up,
long press the “play/pause” button to send the call
to voicemail.
* See the tables on the following pages for complete
button function and LED light indicator interpretation.
F – PAIR 2 ZERO CHILL SPEAKERS
1. Turn on speaker 1 (press and hold the “play/pause”
button for 3 seconds).
2. Turn on speaker 2 (press and hold the “play/pause”
button for 3 seconds).
3. On both speakers, press and hold the “X” and “O”
buttons at the same time for up to 4 seconds and
wait for a tone and the lights to blink green.
4. The speakers will begin to pair together. This will take
a few seconds.
5. Tone prompt will indicate when speakers are paired
together.
6. Choose “Zero Chill” from your device’s Bluetooth list.
7. Press the “play/pause” button on either speaker to
listen to music. Press “X” and “O” together to toggle
between stereo and mono modes.
8. Once paired, your speakers will recognize each other
every time both are turned on. To disconnect Pair 2
mode, press and hold the “X” and “O” buttons for up to
4 seconds. This will enter into pairing mode again.
Note: If either of your speakers has been previously paired
to a device, or will not pair automatically, press and hold
the “play/pause” and “X” buttons on both speakers for 5
seconds to activate pairing mode. You will know they have
reached pairing mode by the red and blue blinking light.
AUX
CHARGE
...3s
...3s
...0.5s
...0.5s
0000
...4s
...2s
0000
Zero
Chill
Zero
Chill
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Jam HX-P606 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info