Bedienungsanleitung JBL CBT series (Seite 20 von 21) (Englisch)

810127

Zoom out

Zoom in

Vorherige Seite

1/21

Nächste Seite

CBT Quick Start Guide 20

Design Conclusions

Vertical Coverage Setting vs. Installation Height – In general, when the CBT speaker is set to the

Narrow vertical coverage setting, the speaker tends to cover best when installed fairly low and angled at a

fairly narrow down-tilt angle in relation to the seating plane.

Note that this mounting height may still be higher than is typically used with other competitive ‘column’

type loudspeakers which often exhibit a narrowing of the vertical beamwidth as the frequency range

increases. By comparison, the CBT Series products maintain a much more even vertical beamwidth,

allowing for more even coverage of the entire audience area.

When the speaker is set to the BROAD vertical coverage setting, it often results in best coverage with the

speaker installed higher and then angling at a steeper down-tilt angle.

Single vs. Multiple CBT Columns – These examples show sectional views of the venues as being

covered by a single CBT loudspeaker, but multiple speakers may be required.

• For Width -- Excellent coverage results can be achieved across the width of most rooms with CBT

speakers allowing expanded left to right placement given the CBT’s wider horizontal coverage

pattern, more so than is typically expected with conventional speaker systems. However, multiple

CBT’s may be needed to cover the width of a room, so a horizontal coverage assessment via a

plan-view should be done.

• For Depth -- It may be advisable to cover balconies or rear seating areas with a second CBT (or

other speaker). The second CBT may be mounted much higher up on the same front wall and set

at its Narrow vertical coverage setting to throw farther. Or, it may be positioned farther back in the

room – closer to the listeners – and delayed to synchronize with any arrival from the front/main

speaker (or with as much additional delay to keep localization to the front speaker, if that is desired

in the application). In this case, the delay speaker would usually be set to the Broad coverage

setting because it is closer to the listeners.

The designer needs to determine the acceptability of time-offset vs. SPL for any overlap areas.

An example of a venue where multiple speakers would be advisable would be a room where there

could be an issue with reflection from the front of a balcony. Using a second speaker with each

focusing sound on its own listening plane could reduce the amount of sound being sent to the front-

of-balcony surface and thereby reduce the amount of sound that is reflected from it back to the

stage (or to seats in the front, which could cause time-smear issues for those listeners).

Front-Fill – While the CBT columns do an admirable job of covering much of the seating area from a

single speaker, it may be worthwhile to add some front-fill speakers to cover front corners of the listening

space. In addition, it may also be useful in some cases to aim the speakers slightly higher or to change

to the Narrow coverage mode and add some mid-high front-fill speakers to cover the first few rows.

This can be a useful technique for further reducing sound reaching a stage area.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JBL CBT series Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info