648488
10
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
7
Use a small Phillips screwdriver to loosen the adapter’s set screws and insert the speaker wires into the holes on the back of the adapter.
Tighten the set screws to secure the wires.
Always connect the (+) speaker wire to the adapter’s (+) terminal and the (–) speaker wire to the adapter’s (–) terminal. When all wires are
connected, plug the adapters into the Club amplifier’s FRONT (and REAR, if using the 4-channel amplifier) preamp inputs.
Remote: Connect a 20-gauge wire from the “Remote Out” lead of the source unit to the REM input. This lead turns the amplifier on when
using low-level input signals.
Ground: Run a wire (the same gauge as the power wire) from the GND input to a factory bolt in the vehicle’s chassis (see illustration below).
NOTE: Remove any paint from the chassis for best contact. Use a star washer below the ring connector for a secure connection.
6. Front and rear inputs and outputs (RCA):
If your source unit offers preamp outputs, connect to the FRONT, REAR, and/or SUB inputs using RCA patch cables.
To connect a second amp directly to the Club-704 amplifier, run a patch cable from the PRE OUT outputs to the second amp’s preamp inputs.
If your car audio system’s head unit does not have line-level outputs:
Use the supplied bare wire-to-RCA adapters to connect the Club amplifier’s inputs to either the front or the rear speaker outputs of your car
audio system’s head unit (splice crimps not included).
Important: Some factory-installed audio system amplifiers include electronic filters that limit the amount of bass sent to the system’s smaller
speakers. This filtering will adversely affect the Club amp’s performance. To get the most bass possible from your Club amp, splice the bare
wire-to-RCA adapters into the factory system speaker outputs that are connected to the system’s largest speakers (the ones designed to make
the most bass).
Factory Bolt
Ring Connector
Ground Wire
Note: Remove any paint
below ring connector
Star Washer
Loosen
Screws
Insert
Wires
Tighten
Screws
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JBL Club-4505 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info