561706
3
Zoom out
Zoom in
Vorherige Seite
1/6
Nächste Seite
3
www.jbl.com
Bass Boost button and LED: Press this button to enhance the bass performance. The
button’s LED will glow when Bass Boost is on.
Club EQ button and LED: Press this button to toggle between two EQ mode settings:
“Basic” and “Club.” The Basic setting offers a stereo perspective, while the Club setting
produces a high-energy, more focused sound. When the EQ is set to Club, the EQ LED will
glow white.
When you are using the JBL MusicFlow app, the following additional EQ settings are
available: Wider Stereo Movie, Rock Music, Jazz Music and Gaming.
Source button and LED: Press this button to cycle through the audio sources: Bluetooth,
docked device and Auxiliary Input. The Source button LED will glow to indicate the active
source: white for a docked device, blue for a paired Bluetooth device and amber for a
device connected to the Auxiliary input.
If you begin to stream audio from a paired Bluetooth device or play audio from a device
connected to the dock while another source is playing, the dock will automatically switch
to the new source.
Power button and LED: When the dock is on, press the Power button to put it into the
standby mode. The button’s LED will glow solid amber when the unit is in standby. When
the dock is in standby, press the Power button to turn it on. The button’s LED will glow
solid white when the unit is on.
When the dock is in the standby mode, it will automatically turn on when it detects audio
playing from a Bluetooth-connected device or from a docked device.
When the dock is on, it will automatically enter the standby mode after 10 minutes of
inactivity (no audio input and no user-control operation). The button’s LED will glow amber
when the dock is in standby.
Note: When the dock enters the standby mode, it will also bring a docked device into
standby mode.
Volume Up/Down buttons: Press these buttons to raise and lower the dock’s
volume. To mute the sound, press both buttons at the same time. (The Power button LED
will flash white when the sound is muted.) To restore the sound, press either Volume button
or both buttons together.
Dock Lid: Gently press down on the front edge of the dock lid to release it and reveal the
multi-pin Lightning docking connector. To close the dock, gently push the lid back in the
enclosure until it clicks.
English
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JBL OnBeat Rumble wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info