701260
4
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
W7AE Subwoofer Drivers: Mounting Guide.
The ultimate no-compromise subwoofer for those seeking extreme output and sublime sound quality.
Step 2: Remove Clamp-Ring
Gently insert the tip of the large flat-head screwdriver between the shiny aluminum clamp-ring
and the foam surround (picture 2a). Be careful not to push the screwdriver too far down or it will
wedge behind the hidden O-Ring (picture 2b). Gently twist the screwdriver to “pop the clamp-ring
off of the O-Ring and frame (picture 2c). This should require little effort... if you are encountering
high resistance, pull the screwdriver up a bit to make sure it is not wedged behind the O-Ring. Once
you have released the tip of the clamp-ring, a gentle push with your thumb in the direction of the
speaker circumference (picture 2d) will separate the clamp-ring fully (picture 2f). Do not pull up on
the ring until it is completely removed (picture 2g).
Please review the mounting procedures thoroughly before attempting to remove the speaker
from its shipping baffle. The W7AE mounts like no other speaker and care must be taken to follow
these instructions precisely.
Step 3: Remove O-Ring
Once the clamp-ring is removed, the
steel O-Ring is exposed. Gently lift this
O-Ring up and off the speaker with your
fingertips and set it aside.
Step 4: Remove Screws
Once the O-Ring is out of the way, the surround is completely
free of the speaker frame (no glue is used to secure it). Lift the surround up and
fold it back inside the speaker frame (picture 4a). This exposes the mounting
screws (picture 4b). The surround should be folded back and in towards the
center of the speaker (picture 4c). Do not pull it up (picture 4d) or invert it
(picture 4e). While holding the surround back with two fingers as shown, back
the first screw out using your electric screwdriver (picture 4f, 4g).
Repeat this process eleven more times (there are twelve screws
on a W7AE) until you have separated the speaker from the
shipping baffle-board. Before you panic, be aware that the
surround and cone materials are rugged and will not be
damaged if you follow the procedures shown. Only careless
acts like picking the speaker up by the surround or creasing
it by force will cause permanent damage.
Step 1: Your Tools
When you remove the W7AE
from its shipping carton, it is
attached to an MDF baffle
board. Make sure you keep
this baffle board and all the
packing material in the unlikely
event that the W7AE ever needs to
be shipped back to JLAudio
for service.
Two tools are required to install a
W7AE: a large flat blade screwdriver
and an electric screwdriver with a #2
Phillips-head bit.
1
2a 2b
2c
2d
2e
2f
2g
3a
3b
4a
4b
4f
4g
4c
4d
4e
Wrong
Correct
Wrong
Correct
Wrong
Wrong
4
4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JL Audio 12W7AE wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info