701229
6
Zoom out
Zoom in
Vorherige Seite
1/8
Nächste Seite
C7-100ct: Surface-Mount Installation
1) Remove the vehicle panel and check
to ensure that the mounting screw
will have adequate clearance.
2) Place the surface-mount fixture on the vehicle
panel at the desired mounting location and
mark the locations of the center mounting screw
hole and the approximate center of the left
and right semicircular cutouts (for the wires).
3) Using a 1/16-inch (1.5 mm) drill bit, drill a pilot hole
through the panel at the center screw location.
4) Using a 1/4-inch (6 mm) drill bit, drill a
hole for each of the tweeters wires at
the locations you marked in step 2.
5) Screw the surface-mount fixture to the vehicle
panel using the supplied #8 sheet metal screw
(hand-tighten) and #8 flat metal spring nut.
Feed a tweeter wire through each semicircular
cutout in the mounting fixture and the
1/4-inch holes you drilled in the panel.
6) To attach the tweeter to the fixture, observe the
indented locking slots on the outer edge of the
tweeter body and align these with the tabs visible
on the inside walls of the fixture. Slide the tweeter
into the fixture and secure by pressing down on
the tweeter and giving it a small clockwise turn.
7) Connect the tweeter’s wires to the wire leads from
the amplifier, observing correct polarity. Install
the protection capacitor as noted on page 5.
8) Re-install the vehicle panel, taking care to route the
new wiring so as not to interfere with any vehicle
mechanisms (window mechanisms, for example).
Diagram B:
Surface-Mount Fixture Installation
6
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JL Audio C7-100ct wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info