MAINTENANCE
1.Running board and running belt
● Brief:
The motorized treadmill use imported running belt, it’s with lower friction coefficient, higher
intensity of tension, the running board is specially with double shock absorption system,
it’s special smoothness and abrasion prevention.
● Clean
Keep cleanness of treadmill, it can prolong treadmill’s life, please usually clean the
exposed running board both side of the running belt and foot board. Clean the running
belt by dipped soap water; please note not to let water flow into machine and under the
running belt.
2. Lubricating
The running board/belt must be lubricated by special lubrication after a period of use,
suggestion:
Treadmill works no more than 3 hours every week. It’s lubricated one time every half of
year.
Treadmill works no 3 to 6 hours every week. It’s lubricated one time every 3 months.
Treadmill works more than 6 hours every week. It’s lubricated one time every month.
Superfluous lubrication is not ok, it’s not good with more lubrication, please remember:
reasonable lubricating is a important factor for prolonging treadmill’s life!
3. Evaluation of friction
The friction between running belt and board will be increased as dust or reduced lubrication,
this perhaps can harm motor, controller increased friction is with following character:
(1) When shut off power of treadmill, the running belt can’t be moved or it’s difficult for user
to move by foot.
(2) Pull out safe key when treadmill runs at middle-speed under load state, the running belt
stops at once.
(3) Causing harm of motor of controller, open circuit and the fuse blows.
4. Adjust flab or tight belt
All running belt are adjusted before the treadmill leaving the factory or after assembling,
but after a period of time of use, the belt will become flab, this circumstance sis out of
guarantee to keep it good repair. The user adjust it by oneself., the flabby belt will cause
slippage between belt and roller, but more tightly belt perhaps harms the motor, roller
and itself. Usually, the space of 50-60mm between belt and footboard when pull the side
of belt is reasonable.
<10>
