28356
39
Zoom out
Zoom in
Vorherige Seite
1/148
Nächste Seite
Section 2 Installation
38
Operating the INSTALLATION menu
To access this menu:
Press
MENU
MENU
key to display the MAIN menu.
Select INSTALLATION> by
Joystick
up/down, push
Joystick
. The
INSTALLATION menu is displayed.
This menu includes various settings required for installation, such
as the selection of the external data input method and unit, or the
initial setting of the radar initial adjustment or the GPS/DGPS
antenna. After installing the RADAR1800, use this menu to make your
settings.
RADAR SET UP
The RADAR ADJUST menu contains settings which should be
done at installation or after any repairs to optimize the performance of
the radar system. It is recommended that the radar be run in transmit
mode for at least 10 minutes before adjusting the Preset Tuning in order
to stabilize the transmitter circuit first. It is also recommended to adjust
the Preset Tuning first as the other adjustments will be easier to do after
that. If Preset tuning is not correct, then the Auto Tune may not work
or may not work correctly and receiving targets will be decreased or
eliminated. If Preset STC is up too high the loss of closer in targets will
occur. These are the 2 most important adjustments for viewing target
echos. Bearing alignment and Range (Timing) adjustments are
important for correct picture orientation and safety.
In the INSTALLATION menu, select RADAR ADJUST> menu
by
Joystick
up/down, push
Joystick
.
The RADAR ADJUST menu is displayed.
TUNE PRESET
From the RADAR ADJUST menu move the
Joystick
up or down
to move the hiliter onto Tune Preset, then press the
Joystick
one time
to select it. The TUNE PRESET popup menu shows the tuning
condition. The bar graph in the bottom of the screen shows the relative
position of the adjustment control. Move the
Joystick
right or left
while watching the echo targets and the upper bar graph. The upper bar
graph should peak to the right at the same point where the targets show
as the largest. When you achieve the best adjustment, push the
Joystick
once to save it.
Perform this step after the radar has been transmitting for 10 minutes.
•Set the range scale to 3 NM.
•Turn SEA and RAIN all the way down.
•Turn IR off.
•Set gain to a level just below the level where noise specks show on the
screen.
•In the RADAR ADJUST menu, select TUNE PRESET by
Joystick
up/down, and push
Joystick
.
The TUNE PRESET pop-up menu is displayed.
•Move the bar by
Joystick
right/left to get the strongest signal back.
OFF
N 0° 00.000’
E 0° 00.000’
00/00/0000
00:00
12HOUR
SIMULATION
INITIAL POS.
CLOCK ADJUST
DATE & TIME
RADAR ADJUST>
DATA IN/OUT >
UNITS >
CALIBRATION >
OPERATION >
INSTALLATION
EBL BEARING
PRF SHIFT
BEARING
DISPLAY TIMING
TUNE PRESET
STC PRESET
RADAR ADJUST
REL
20
0
561
32
57
TUNE PRESET
40
39

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JRC Radar1800 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info