28358
29
Zoom out
Zoom in
Vorherige Seite
1/55
Nächste Seite
22
4.3 SELECTING A RANGE
The actual range scale and range rings interval is shown in the upper left corner
of the display. Press the RANGE key for an increased range scale, or key
for a decreases range scale. The selected range automatically determines the
proper number and distance between the range rings.
4.4 ADJUSTING RECEIVER SENSITIVITY
Press the J-DIAL until GAIN appears highlighted on the upper right corner of
the display. Rotate the J-DIAL clockwise or counterclockwise, to vary the gain
and thus control the strength of echo returns on the radar screen. An on-screen
bar indicates the gain level selected for display. The proper setting is when the
background noise is just visible on the screen.
4.5 ADJUSTING TUNING
The RADAR 3000 is setting Auto Tune mode at the power ON. If wish to
manual tuning, required to select Manual Tune mode by using menu (Refer to
4.27).
Press the J-DIAL until the TUNE appears highlighted on the upper right corner
of the display. Rotate the J-DIAL clockwise or counterclockwise, to maximize
the target echo. If land targets are not within the radar’s range, adjust the control
for maximum sea clutter. The on-screen tuning indicator will shown the strength
of tuning peak conditions is turned for maximum deflection. Normally, tuning
is performed on the 3 NM range scale or higher. Minor readjustment may be
necessary after the radar has warmed up 10 minutes.
OPERATION
22
4.3 SELECTING A RANGE
The actual range scale and range rings interval is shown in the upper left corner
of the display. Press the RANGE key for an increased range scale, or key
for a decreases range scale. The selected range automatically determines the
proper number and distance between the range rings.
4.4 ADJUSTING RECEIVER SENSITIVITY
Press the J-DIAL until GAIN appears highlighted on the upper right corner of
the display. Rotate the J-DIAL clockwise or counterclockwise, to vary the gain
and thus control the strength of echo returns on the radar screen. An on-screen
bar indicates the gain level selected for display. The proper setting is when the
background noise is just visible on the screen.
4.5 ADJUSTING TUNING
The RADAR 3000 is setting Auto Tune mode at the power ON. If wish to
manual tuning, required to select Manual Tune mode by using menu (Refer to
4.27).
Press the J-DIAL until the TUNE appears highlighted on the upper right corner
of the display. Rotate the J-DIAL clockwise or counterclockwise, to maximize
the target echo. If land targets are not within the radar’s range, adjust the control
for maximum sea clutter. The on-screen tuning indicator will shown the strength
of tuning peak conditions is turned for maximum deflection. Normally, tuning
is performed on the 3 NM range scale or higher. Minor readjustment may be
necessary after the radar has warmed up 10 minutes.
OPERATION
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JRC Radar3000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info