661766
16
Zoom out
Zoom in
Vorherige Seite
1/22
Nächste Seite
14
Operation Method
Refrigeration mode
·
·
·Press the wind speed button to select high, medium or low wind speed.
Fan only mode
.
·Press the wind speed button to select high, medium or low wind speed.
Temperature cannot be set.
Dehumidification mode
·Select dehumidification mode by pressing mode button or
via remote controller, and the dehumidification indicator light
is on.
·When entering dehumidification mode, if the room
temperature is15 (or 59), the compressor will start to
work. Then control according to the following rules: when
room temperature is13(or 55), compressor stops; when
the temperature rises back to 15, the compressor restarts
(the restart of compressor shall meet the 3-minute delay protection function).
·In dehumidification mode, the fan run in low speed by default, and the wind
speed are not adjustable.
·Temperature cannot be set.
(Usage tip: when the dehumidification function is in use, the exhaust pipe
assembly shall be removed; otherwise it will lead to not obvious dehumidification
effect or display FL water full alarm.)
Automatic mode (only for single refrigeration type)
·select automatic mode by pressing mode button or via remote controller, and
automation indicator light is on.
·after selecting the automatic mode, it decides running state based on ambient
temperature: When the ambient temperature is higher than
25, the running mode
is the refrigeration mode; When the ambient temperature is lower than
25, the
running mode is the fan only mode.
After being powered and turned on, its refrigeration mode by default or pressing
mode button to select refrigeration mode, and the refrigeration indicator light is
on.
Press the up or down button to adjust the set temperature (17°C--30°C) .
• Press the mode button or via the remote controller to select fan only mode,
and fan only indicator light is on.
• As shown in the picture below, remove the plug of drainage
cap, insert the aqueduct, and put another end of the
aqueduct into water containers or drain channels.
16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Just Fire 9000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info