595810
5
Zoom out
Zoom in
Vorherige Seite
1/49
Nächste Seite
6
1. INTRODUCTION
1-1 Precautions for Proper Use
Supply voltage
Make sure that the power is between 11 V and 15 V DC. If
the power voltage is too low, abnormal color and increased
noise may occur. Do not exceed 15 V DC in any case, or the
unit could be damaged.
Allowable ambient temperature and humidity
Be sure to use the unit within the allowable temperature range
of 0°C to 40°C and a relative humidity of 30% to 80%. Using
the unit at a temperature or humidity outside the allowable
ranges could result not only in malfunction but the impact on
the CCD elements could be serious as small white spots
may be generated. When storing the GY-DV5000 for a long
time, the storage temperatures should be -20°C to 60°C.
Strong electromagnetic waves or magnetism
Noise may appear in the picture or audio and/or the colors
may be incorrect if the camera is used near a radio or
television transmitting antenna, in places where strong
magnetic fields are generated by transformers, motors, etc.,
or near devices emitting radio waves, such as transceivers
or cellular phones.
Use of wireless microphone near the camera
When a wireless microphone or wireless microphone tuner
is used near the camera during recording, the tuner could
pick up noise.
Avoid using or placing the unit in places;
subject to extreme heat or cold;
with excessive dirt or dust;
with high humidity or moisture;
• subject to smoke or vapour such as near a cooking stove;
subject to strong vibrations or on an unstable surface.
also do not leave the unit for long hours in a parked car
under direct sunlight or near room heating equipment.
Do not leave the unit where it is subject to radiation or x-
rays or where corrosive gasses occur.
Protect the unit from being splashed with water
(especially when shooting in the rain).
Protect the unit from being wet when shooting on a beach.
In addition, salt and sand may adhere to the camera body.
Be sure to clean the camera after use.
Protect the unit against penetration of dust when using it in a
place subject to sandy dust.
Setup level
The video signal of the unit’s video output is provided with a
setup level when shipped from the factory. If you want to turn
OFF the setup level, set the SET UP item on the AUDIO/
VIDEO menu screen to 0.0%.
Optical performance of lens
Due to the optical performance of the lens, color divergence
phenomena (magnification chromatic aberration) may occur
at the periphery of the image. This is not a camera
malfunction.
Noise may appear in the viewfinder when switching between
the playback picture and the EE picture.
Use the unit in an upright position.
If placed on its side, heat release efficiency will deteriorate,
adversely affecting the tape transport. Depending on
circumstances the tape may also be damaged.
Vibrations
Colors may fail to appear and/or the image and sound may
be disturbed during VTR playback in locations subjected to
strong vibrations.
Precautions for transportation
Do not drop or hit the unit against a hard object.
Remove the videocassette before transporting the unit.
Do not insert an object other than a videocassette in the
cassette insertion slot. Be sure to close the cassette cover
when the unit is not to be used for a long period.
Do not set the POWER switch to OFF or remove the power
cable during recording or playback. Otherwise the tape may
be damaged.
The sensitivity level of the provided microphone is set lower
than the reference input (- 60 dBs) setting.
When the unit is not in use, be sure to set the POWER switch
to OFF in order to reduce power consumption.
Cleaning the body: Wipe body with a dry, soft cloth. When it
is extremely dirty, soak the cloth in a solution of neutral
detergent, wipe the body with it, and then use a clean cloth
to remove the detergent. To prevent deformation of the body,
etc. and to avoid operation hazards, do not allow volatile
liquids such as benzine and thinner to touch the body, and
do not wipe it with a cloth soaked in such a liquid.
The camera may not show stable pictures in the period
immediately after the power is turned on, but this is not a
malfunction.
If a tape containing recorded PAL signals is played back,
“PAL INHIBIT” is displayed and correct playback will not take
place. If this happens, remove the videocassette so that the
unit returns to its normal state.
When turning on the power with the tape inserted or after
loading a tape, the built-in head cleaner will emit a sound
while operating. However, this is not a malfunction of the unit.
The LCD screen and the viewfinder screen are manufactured
using high-precision technology. Black spots may appear on
the LCD screen and the viewfinder screen, or red, blue, green
and/or white spots may not turn off. However, this is not a
malfunction and these spots are not recorded on the tape.
Do not insert fingers or foreign objects into the cassette
insertion slot as this may result in personal injury or damage
to the mechanism.
CAUTION :
Do not point the lens or viewfinder directly at the sun or
other strong light source.
•Eye damage could result.
If the lens or viewfinder is left pointed at the sun, rays
may collect inside the unit and cause damage or a fire.
When carrying the camera, be sure to hold the carrying
handle. Holding the lens or viewfinder may result in
damage.
7
1. INTRODUCTION
Head Cleaning
To maintain beautiful pictures and sound, be sure to use a
head cleaning tape to clean the head periodically. (Read the
“Precautions for Use of Head Cleaning Tape” on page 8.) If
head cleaning is not performed periodically, a type of mosaic
noise called block noise may appear in the picture or sound
may be interrupted.
Please use cleaning tape produced by JVC. Do not use head
cleaning tapes other than specified. Read the precautions
and instructions for use of the head cleaning tape on page 8.
When dust adheres to the heads, the warning message
“HEAD CLEANING REQUIRED!” is displayed on the LCD
monitor and in the viewfinder during playback, edit search,
and recording check using the RET button on the lens section.
The GY-DV5000 incorporates precision mechanical parts, which will collect dirt, wear out and deteriorate as the unit is used. After
the unit has been used for a long period even in a normal environment, the heads, drums and tape transport mechanisms also
collect dirt. Especially, dust which penetrates the inside of the VCR section during outdoor use will promote the wear and deterioration
of mechanical parts by causing poor contact between tape and heads or failing to maintain the video and audio quality at high
levels. To prevent wear and deterioration, clean the mechanical parts using a head cleaning tape as routine maintenance. However,
cleaning with a head cleaning tape alone is not enough for cleaning the entire tape transport mechanism, so it is also recommended
to apply periodical maintenance (inspection) to prevent the sudden occurrence of failure. As the replacement, adjustment and
servicing of parts require advanced skill and equipment, please consult the person in charge of professional video equipment at
your nearest JVC-authorized service agent.
1-2 Routine and Periodical Maintenance
Periodical Maintenance
Contents : Check or replace the following mechanical parts
according to the running time.
The maintenance contents vary depending on the operating
environment and method. Therefore, the above data should
be considered as a reference.
Time management
The accumulated running time of the unit can be confirmed
with the hour meter display (which shows the accumulated drum
running time). For details, see “HOUR METER DISPLAY” on
page 91.
For consultations related to the maintenance planning or
cost, please contact the person in charge of professional
video equipment at your nearest JVC-authorized service
agent.
: Check
: Clean, check and adjust.
: Clean and check. Replace as required.
: Replace.
Running Time
500H
1000 H 1500H
2000H 4000H
Drum ass’y (including heads)
䡬䡬䡬䢇䢇
Head cleaner
夡䢇夡䢇䢇
Tape guides & rollers
䡬夡夡䢇䢇
Rotary encoder
–––夡䢇
Gears
䢇䢇
Drive parts 夡䢇
Block Noise
HEAD CLEANING REQUIRED!
For servicing
Refer to the service manual page. 2-6 “2.4.3 Cleaning”
5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JVC GY-DV5000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info