Bedienungsanleitung JVC UX-G500 (Seite 4 von 52) (Englisch)

56641

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

How to Read This Manual

• Button and control operations are explained in the table

below.

• Some related tips and notes are explained later in

the sections “Learning More about This System”

and “Troubleshooting,” but not in the same section

explaining the operations (

INFO

indicates that the

content has some information).

Indicates that you press the button briefly.

Indicates that you press the button briefly

and repeatedly until the option you want

is selected.

Indicates that you press one of the buttons.

sec.

Indicates that you press and hold the

button for a specified period.

Indicates that you turn the control in the

specified direction(s).

Remote

ONLY

Indicates that this operation is only

possible using the remote control.

Main Unit

ONLY

Indicates that this operation is only

possible using the main unit.

How to cancel the demonstration

Press and hold DEMO button on the main unit (until

“DEMO CLR” appears on the display) while on standby.

• Refer to the attached sheet “Information about the

demonstration function.”

Introduction

Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete

understanding and to obtain the best possible performance from the System.

Precautions

Installation

• Install the System in a location with adequate ventilation

to prevent internal heat build-up in the System.

DO NOT install the System in a location near

heat sources, or in a place subject to direct

sunlight, excessive dust or vibration.

• Install in a place which is level, dry and neither too hot

nor too cold—between 5°C and 35°C.

• Leave sufficient distance between the System and the TV.

• Keep the speakers away from the TV to avoid

interference with the TV.

Power sources

• When unplugging the System from the wall outlet, always

pull on the plug, not the power cord.

DO NOT handle the power cord with wet

hands.

Moisture condensation

Moisture may condense on the lens inside the System in the

following cases:

• After starting to heat the room

• In a damp room

• If the System is brought directly from a cold to a warm

place.

Should this occur, the System may malfunction. In this

case, leave the System turned on for a few hours until the

moisture evaporates, unplug the power cord, then plug it

in again.

Internal heat

• Make sure there is good ventilation around the System.

Poor ventilation could overheat and damage the System.

DO NOT block the ventilation openings or

holes. If they are blocked by a newspaper or

cloth, etc., the heat may not be able to get out.

Others

Should any metallic object or liquid fall into the System,

unplug the power cord and consult your dealer before

operating any further.

DO NOT disassemble the System since there

are no user serviceable parts inside.

• If you are not going to operate the System for an

extended period of time, unplug the power cord from the

wall outlet.

If anything goes wrong, unplug the power cord and consult

your dealer.

EN01-08_UX-G500V[B]f.indd 1EN01-08_UX-G500V[B]f.indd 1 3/4/08 10:06:15 AM3/4/08 10:06:15 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

JVC UX-G500 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von JVC UX-G500

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info