614784
19
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
16
SLEEP
Sleep time settings of 30, 60, 90 or 120 minutes can be set. When you
release the SLEEP button, the source is displayed after 5 sec.
The sleep timer operation will start and the power will be switched off
after the specified time.
Checking the sleep time
When the SLEEP button is pressed, the remaining sleep time is dis-
played. If it is pressed again, a new sleep time can be set.
To cancel the sleep timer operation
Press the button to switch the power off or press the SLEEP
button until the sleep time indicator disappears.
Any source can be selected for sleep timer operation and timer play-
back. For example;
CD play for sleep timer operation and broadcast reception for timer
playback.
Tape playback for sleep timer operation and CD play for timer play-
back.
However, when broadcast reception is selected for both sleep timer
operation and timer playback, the station you heard at night will be tuned
to the following morning.
Source mode display (Releasing the sleep mode)
SLEEP is shown in the display.
SLEEP
Source mode display (Releasing the sleep mode)
Sleep timer operations (using the remote control unit)
A. Use this when you want to fall asleep while listening to a tape,
broadcast or CD.
1 Set to the required source and tune (broadcast) or play back (CD or
tape).
2 Press the SLEEP button to set the sleep time.
B. To fall asleep while listening to a tape, broadcast or CD and to
perform timer playback the following morning
1 Set the timer. (Refer to “Setting the timer” on page 14.)
2 Set to the required source (broadcast, tape or CD).
3 Press the SLEEP button to set the sleep time.
TROUBLESHOOTING
What appears to be trouble is not always serious. First make sure....
Power cannot be turned on.
* Is the power cord unplugged?
No sound from the speakers.
* Are headphones connected?
CD Player Section
The CD player does not play.
* Is the CD upside down?
* Is the CD dirty?
A certain portion of the CD does not play correctly.
* Is the CD scratched?
Cassette Deck Section
Playback sound is at a very low level.
* Is the head dirty?
The ONE TOUCH REC button does not function.
* Have the safety tabs of the cassette been broken off?
Tuner Section
Reception is noisy.
* Try adjusting the antenna.
Timer Section
Timer operation does not start.
* Is the current time set correctly?
* Is the timer mode ( ) displayed?
Remote Control
Remote control is impossible.
* Are the batteries in the remote control exhausted?
* Is the remote sensor section exposed to bright light (direct sunlight,
etc.)?
Note:
Before making an important recording, be sure to make a test record-
ing first to check that the deck, etc. is working correctly.
When the above remedies do not help
Many operations of this unit are performed by the control of a
microprocessor. If none of the buttons function, unplug the power
cord, wait for a while, then plug it back in. Reset the correct val-
ues for the clock and timer.
Cleaning is important!
When the tape is running, magnetic powder and dust naturally accu-
mulate on the heads, capstan and pinch roller. When they become too
dirty...
Sound quality deteriorates.
The output sound level drops.
Previously recorded tape is not completely erased.
Recording is not performed satisfactorily.
Therefore, you should clean the heads, etc. after every 10 hours of use
for optimal recording conditions.
Cleaning the heads, capstan and pinch roller
Open the cassette holder.
Clean the heads, pinch roller and capstan.
For effective cleaning, use a cleaning kit available from an audio store.
After cleaning, be sure that the cleaning fluid has dried completely be-
fore loading a cassette.
MAINTENANCE
Cautions:
1. Keep magnets and metallic objects away from the
head.
If the head becomes magnetized, noise will increase and the sound
will deteriorate. Demagnetize the head every 20–30 hours of use
with a head eraser (available from an audio store). (When demag-
netizing the head, the button should be set to STANDBY.)
2. Do not use anything other than alcohol for cleaning.
Thinner and benzine will damage the rubber pinch roller.
Cleaning the lens
If the lens in the CD pickup is dirty, dropout, etc., could degrade sound.
Open the CD holder and clean the lens as shown.
Use a blower (available from a camera store) to blow dust off the lens.
If there are fingerprints, etc. on the lens, gently wipe clean with a
cotton swab.
Capstan shaft(s)
Pinch roller(s)
Combination record/play head
Erase head
Lens
Blower
UX-T550(B)_body.pm6 12/12/00, 3:11 PM16
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für JVC UX-T550 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info