Generated by Unregistered Batch DOC TO PDF Converter 2011.3.804.1511,
please register!
13
Automatic operation
When the air conditioner is ready for use, switch on the power and the OPERATION
indicator lamp on the display panel of the indoor unit starts flashing.
1. Use the MODE select button to select AUTO.
2. Push the TEMP button to set the desired room temperature.
The most comfortable temperature settings are between 21。C/70OF to 28oC/82OF
3. Push the ON/OFF button to start the air conditioner. The OPERATION indicator on the
display panel of the indoor unit lights. The operating mode of AUTO FAN SPEED is
automatically set and there are no indicators shown on the display panel of the
remote control.
4. Push the ON/OFF button again to stop the unit operation.
NOTE
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN,
HEAT and DRY by sensing the difference between the actual ambient room
temperature and the set temperature on the remote control.
2. If the AUTO mode is not comfortable for you, the desired mode can be selected
manually.
COOL, HEAT, and FAN ONLY Operation
1. If the AUTO mode is not comfortable, you may manually override the settings by
using COOL, DRY, HEAT (HEAT PUMP units only), or FAN ONLY modes.
2. Push the TEMP button to set the desired room temperature. When in COOLING mode,
the most comfortable settings are 21。C/70OFor above. When in HEATING mode, the
most comfortable settings are 28oC/82OFor below.
3. Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4. Push the ON/OFF button. The operation indicator lights and the air conditioner starts
to operate per your settings. Push the ON/OFF button again to stop this unit
operation
NOTE: The FAN ONLY mode cannot be used to control the temperature. While in this
mode, only steps 1、3 and 4 may be performed.
DRY OPERATION
1. Push the MODE button to select DRY.
2. Push the TEMP button to set the desired temperature from 21。C/70OF to 28oC/82OF.
3. Push the ON/OFF button. The operation lamp lights and the air conditioner starts to
operate in the DRY mode. Push the ON/OFF button again to stop this unit operation.
TIMER Operation
TIMER ON button can set the auto-on time of the unit. TIMER OFF button can set the
auto-off time of the unit.
A. To set the starting time.
1. Push the TIMER ON button, then the remote control shows TIMER ON, the last set time
for the starting operation and the signal "h" will be shown on the DIGITAL DISPLAY
area. You are now ready to reset the time to START the operation.
2. Push the TIMER ON button again to set desired unit start time.
3. After setting the TIMER ON, there will be a one-half second delay before the remote
control transmits the signal to the air conditioner. Then, after approximately another 2
