733551
42
Zoom out
Zoom in
Vorherige Seite
1/44
Nächste Seite
42 | EN
18. Headphone Connector
A headphone jack is located at back of the unit. When the unit is powered on and playing music, you
can connect headphones (not included) to the headphone jack for your private listening. Mind the
safety information from page 24 on.
With headphones connected the unit’s speakers are disabled. To listen via the speakers again, discon-
nect the headphones.
19. Troubleshooting
Error Remedy
The device does not switch on
or turns o󰀨 suddenly.
1. Check if the power adaptor is connected properly.
2. The device may malfunction when used in areas with strong
radio interference. The device will work properly again once
interference ceases.
No sound or low sound. 1. Turn on the sound as it may be muted.
2. Increase the volume.
3. Pull any connected headphone or speaker from the connector
sockets.
4. AUX In mode: Check if the audio cable is connected properly
and the volume of the source is large enough.
No network connection can be
established. 1. Check the WLAN function.
2. Try to set an IP address at the device.
3. Activate the DHCP function on the router and make the con-
nection again at the device.
4. Check if the rewall is activated on the network – set the
respective program in such a way that access is possible.
5. Reboot the router.
WiFi connection cannot be
established. 1. Check the availability of WLAN network on the router.
2. Place the device closer to the router.
3. Make sure the password is correct.
WiFi gets disconnected. 1. If the connection is lost in standby mode, make sure that the
setting “Keep network connected” (in Setup Wizard or menu
System settings > Network > Keep network connected) is set
to “Yes”.
No station is found. 1. Check the network as well as the access point and rewall.
2. The station may not be available currently, try it again later or
select another station.
3. The link of the station is changed or the station no longer
transmits.
4. The link of manual added station is not correct, make sure it is
correct and re-enter.
No signal or hiss in DAB or FM
mode. 1. Check/move the antenna. Also try to adjust the length of
antenna.
2. Move the radio to another location.
3. FM mode: Set the Audio Setting to “Forced Mono”.
No stations available / burbling
/ intermittent in DAB mode. 1. Move the radio.
2. Rescan local stations only (high-strength).
3. Check the local DAB+ coverage.
42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Karcher Audio DAB9000CDi wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info