652940
22
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
22 | EN
active.
2. To deactivate the timer function, press the TIMER button again until the timer symbol disap-
pears from the display.
Sleep Function
The sleep function enables you to set a countdown timer after which the unit will turn itself into standby
mode automatically.
While listening, repeatedly press the SLEEP button to select a desired countdown after which the
system will turn itself into standby mode automatically.
You can select 90, 80, 70, ... 10 minutes.
If you want to cancel the function, press and hold the SLEEP button until the “SLEEP” indicator-
will disappear from the display.
Equalizer Presets
While listening, repeatedly press the EQ button to change the equalizer preset as follows:
Flat Jazz Rock Classic Pop
Mute Function
Press the MUTE button to turn off the volume. Press the MUTE button again to reactivate the sound.
Headphone Connector
You can connect 3.5 mm headphones to the headphone connector at the front of the unit. When head-
phones are connected the speakers are disabled. To enable the speakers again simply disconnect the
headphones.
X-Bass
Press the X-Bass button to enhance the bass.
Radio
1. Switch the unit on as described previously.
2. Set the system to radio mode by pressing the TUNER button.
3. Select a desired radio station by pressing the TUNING+ or TUNING- button repeatedly.
4. To automatically search for the next available radio station, press and hold for 2 seconds the
TUNING+ or TUNING- button.
5. Adjust the volume to a desired level using the VOLUME UP/DOWN button.
FM & FM Stereo Reception
When a radio station is transmitting in stereo, you can set the FM MODE selector to “ST” for best
reception. “ST” will be shown in the display.
If reception of a station is weak, set the FM MODE selector to “Mono” to receive a better recep-
tion.
Notes for better reception:
FM: This unit has an FM wire antenna. For best reception, fully unwind it.
Radio Station Presets
This unit enables you to store up to 20 radio stations.
1. Tune to a radio station which you would like to store.
2. Press the MEM/CLK-ADJ button to enter the programming mode.
3. Press the REPEAT/M-UP button to select a desired preset place where you want to store the
current frequency.
4. Press the MEM/CLK-ADJ button to conrm your setting.
5. Repeat steps 1 - 4 to store more frequencies.
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Karcher Audio KA 5300 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info