633365
14
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
14
KAF-3010R/1010 (En)
In case of difficulty
NoteNote
Note
Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for
they may deform the plastic components.
Operation to reset
The microcomputer may fall into malfunction (impossibility to
operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom-
puter and return it to normal condition.
Set the POWER to OFF then, while holding down the SOURCE
DIRECT key, set the POWER switch to ON.
Symptom
Remote control unit (KAF-3010R only)
Cause Remedy
Batteries are exhausted.
The remote control unit is too far away
from the main system, controlling angle is
too large, or there is an obstacle in be-
tween.
The audio cords and system control cords
are not connected properly.
The source component to be operated
does not contain the tape(s) or CD.
The POWER switch is set to OFF.
Remote control operation is not possible
Replace with new batteries. 9
Operate the remote control unit within the
controllable range.
9
Connect properly referring to “System
connection”.
45
Place the tape(s) or CD in the source com-
ponent to be played.
Set the POWER switch to ON. 0
Speaker protection circuit
When this unit’s power is turned ON with the speaker cable short-circuited, the speaker protection functions.
If the standby indicator blinks (KAF-3010R) or the MUTING indicator blinks (KAF-1010) and no sound occurs, turn the power
OFF, remove the short-circuit, then turn the power ON again.
Please note that resetting the microcomputer clears the contents
stored in it and returns it to the condition when it left the factory.
The speaker cords are disconnected.
The VOLUME CONTROL is set to the
minimum position.
MUTING is ON.
(The MUTING indicator is blinking)
The SPEAKERS switches are set to OFF.
The system control cords are not fully con-
nected.
Speaker cords are short-circuited.
The speaker cord is disconnected.
The BALANCE control is set to an extreme
position.
Symptom
Cause Remedy
Connect them properly referring to “Sys-
tem connection”.
6
Adjust the volume to a proper level.0
Press the MUTING key to OFF. !
Set the SPEAKERS switch(es) to ON.
0
Check the system control connections.
45
Turn the power off, eliminate the short-cir-
cuiting, then turn on the power again.
Connect it properly referring to “System
connection”.
6
Adjust the Left/Right balance. !
Sound is not output.
The standby indicator blinks and sound
is not output. (KAF-3010R)
The MUTING indicator blinks and sound
is not output. (KAF-1010)
Sound is not output from one of the
speakers.
Amplifier
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below
to see if the problem can be corrected before seeking help from your dealer or service representative.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kenwood KAF-3010R wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info