Bedienungsanleitung Kenwood KDC-W313A (Seite 19 von 20) (Englisch)

68541

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

English

Troubleshooting Guide

Some functions of this unit may be disabled by

some settings made on this unit.

! Cannot display the user of System Q.

▲

<Audio Control> (page 6) is not set.

! • Cannot set up the subwoofer.

• No output from the subwoofer.

• Cannot set up the low pass filter.

▲

• Preout is not set to subwoofer. ☞ “SWPRE” of

<Menu System> (page 10)

• <Subwoofer output> (page 4) is not set to On.

! • Cannot register a security code.

• Cannot set up Display.

• Power OFF Timer does not function.

▲

<Demonstration mode Setting> (page 12) is not

turned off.

What might seem to be a malfunction in your unit

may just be the result of slight misoperation or

miswiring. Before calling service, first check the

following table for possible problems.

Tuner source

? Radio reception is poor.

✔ The car antenna is not extended.

☞ Pull the antenna out all the way.

Disc source

? The specified disc does not play, but another one

plays instead.

✔ The specified CD is quite dirty.

☞ Clean the CD referring to the CD cleaning of the

section on <Handling CDs> (page 3).

✔ The disc is loaded in a different slot from that

specified.

☞ Eject the disc magazine and check the number

for the specified disc.

✔ The disc is severely scratched.

☞ Try another disc instead.

Audio file source

? The sound skips when an Audio file is being

played.

✔ The media is scratched or dirty.

☞ Clean the media, referring to the CD cleaning of

the section on <Handling CDs> (page 3).

✔ The recording condition is bad.

☞ Record the media again or use another media.

The messages shown below display your

systems condition.

TOC ERR: • No disc has been loaded in the disc

magazine.

• The CD is quite dirty. The CD is upside-

down. The CD is scratched a lot.

E-05: The disc is unreadable.

E-15: Media was played that doesn’t have data

recorded that the unit can play.

E-77: The unit is malfunctioning for some reason.

➪ Press the reset button on the unit. If the “E-

77” code does not disappear, consult your

nearest service center.

E-99: Something is wrong with the disc magazine.

Or the unit is malfunctioning for some reason.

➪ Check the disc magazine. And then press

the reset button on the unit. If the “E-99”

code does not disappear, consult your

nearest service center.

IN (Blink): The CD player section is not operating

properly.

➪ Reinsert the CD. If the CD cannot be

ejected or the display continues to flash

even when the CD has been properly

reinserted, please switch off the power

and consult your nearest service center.

PROTECT: The speaker wire has a short-circuit or

touches the chassis of the vehicle, and then

the protection function is activated.

➪ Wire or insulate the speaker cable

properly and press the reset button. If

the “PROTECT” code does not disappear,

consult your nearest service center.

NA FILE: An Audio file is played with a format that this

unit can’t support.

➪ ----

COPY PRO: A copy-protected file is played.

➪ ----

B64-4214-00_00_En.indd 19B64-4214-00_00_En.indd 19 08.7.25 10:26:31 AM08.7.25 10:26:31 AM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood KDC-W313A Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood KDC-W313A

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info