Bedienungsanleitung Kenwood kdc-w6534u (Seite 3 von 48) (Englisch)

163718

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

English

Safety precautions

About CD players/disc changers

connected to this unit

Kenwood disc changers/ CD players released in

1998 or later can be connected to this unit.

Refer to the catalog or consult your Kenwood

dealer for connectable models of disc changers/

CD players.

Note that any Kenwood disc changers/ CD players

released in 1997 or earlier and disc changers made

by other makers cannot be connected to this unit.

Connecting unsupported disc changers/CD players

to this unit may result in damage.

Set the "O-N" Switch to the "N" position for the

applicable Kenwood disc changers/ CD players.

The functions you can use and the information

that can be displayed may differ depending on the

models being connected.

• You can damage both your unit and the CD changer if

you connect them incorrectly.

Lens Fogging

When you turn on the car heater in cold weather,

dew or condensation may form on the lens in the

CD player of the unit. Called lens fogging, this

condensation on the lens may not allow CDs to

play. In such a situation, remove the disc and wait

for the condensation to evaporate. If the unit still

does not operate normally after a while, consult

your Kenwood dealer.

2WARNING

To prevent injury or fire, take the

following precautions:

• To prevent a short circuit, never put or leave any

metallic objects (such as coins or metal tools)

inside the unit.

• Mounting and wiring this product requires

skills and experience. For safety’s sake, leave the

mounting and wiring work to professionals.

Attach the panel while you are on the

vehicle

The panel lock arm appears when the panel is

removed. Therefore, the panel must be attached

while the electrical system of the car is operating.

2CAUTION

To prevent damage to the machine, take

the following precautions:

• Make sure to ground the unit to a negative 12V

DC power supply.

• Do not install the unit in a spot exposed to direct

sunlight or excessive heat or humidity. Also avoid

places with too much dust or the possibility of

water splashing.

• Do not place the faceplate (and the faceplate

case) in areas exposed to direct sunlight, excessive

heat or humidity. Also avoid places with too much

dust or the possibility of water splashing.

• To prevent deterioration, do not touch the

terminals of the unit or faceplate with your

fingers.

• Do not subject the faceplate to excessive shock,

as it is a piece of precision equipment.

• When replacing a fuse, only use a new fuse with

the prescribed rating. Using a fuse with the wrong

rating may cause your unit to malfunction.

• Do not apply excessive force to the open

faceplate or place objects on it. Doing so will

cause damage or breakdown.

• Do not use your own screws. Use only the screws

provided. If you use the wrong screws, you could

damage the unit.

Do Not Load 8 cm (3 in.) CDs in the CD

slot

If you try to load a 8 cm (3 in.) CD with its adapter

into the unit, the adapter might separate from the

CD and damage the unit.

The "AAC" logo is trademark of Dolby

Laboratories.

B64-3346-00_00.Indd 3B64-3346-00_00.Indd 3 06.1.27 0:06:59 PM06.1.27 0:06:59 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood kdc-w6534u Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info