Bedienungsanleitung Kenwood KOS-A210 (Seite 36 von 40) (Englisch)

465257

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

KOS-A210

Troubleshooting Guide

Some functions of this unit may be disabled by

some settings made on this unit.

! • Cannot set up Display.

▲

<Cancel the Demonstration mode> (page 5) is not

turned off.

What might seem to be a malfunction in your unit

may just be the result of slight misoperation or

miswiring. Before calling service, first check the

following table for possible problems.

General

? The sound skips when an Audio file is being

played.

✔ The recording condition is bad.

☞ Record the media again or use another media.

? The unit cannot be turned ON.

✔ The unit is malfunctioning for some reason.

☞ Turn off the vehicle engine switch and then on.

✔ The terminal connection is not appropriate.

☞ Check the connection of the controller, etc.

? The audio becomes distorted.

✔ The modulation level of the transmitter is high.

☞ Adjust “MENU”

> “ModulationLV” (“MOD LV”) of

<Function Control> (page 6)

? The receiver sensitivity of the vehicle radio is bad.

✔ The transmitter function of this unit is affecting the

radio.

☞ Turn off the power of this unit. Set “MENU”

“Power Off Mode” (“PWR OFF”) of <Function

Control> (page 6) to “1” when the setting is “2”.

Hands-free

? No sound is heard from the rear speakers.

✔ You are talking in the hand-free talk mode.

☞ No sound is heard from the rear speakers in the

hands-free talk mode.

? No beep is heard at reception of an incoming call.

✔ No beep is heard depending on the type of your

cell-phone.

☞ The “MENU”

> “Call Beep” of <Function Control>

(page 6) is set ON.

? Voice is not recognized.

✔ The vehicle window is open.

☞ If the surrounding noise is large, voice cannot be

recognized properly. Close the vehicle windows

to reduce noise.

✔ Small voice.

☞ If voice is too small, it cannot be recognized

properly. Speak into the microphone a little more

loudly and naturally.

✔ The person speaking the voice tag is not the one

who registered it.

☞ Only the voice of the person who registered the

voice tag can be recognized.

Bluetooth audio source

? The Bluetooth audio player cannot be registered

(pairing).

✔ The PIN code is fixed.

☞ When a PIN code is specified in the Instruction

Manual for Bluetooth Audio Player, register it

with reference to <Registering PIN Code> (page

20) to register the Bluetooth audio player. If no

PIN code is specified in the Instruction Manual,

try “0000”.

? The sound from the Bluetooth audio player is

intermitent.

✔ The distance between this unit and audio player is

too far.

☞ Move the audio player nearer to this unit.

✔ Another Bluetooth device is affecting the Bluetooth

communication.

☞ Turn off another Bluetooth device.

☞ Move another Bluetooth device away from this

unit.

✔ Another Bluetooth device or profile is used for

communication.

☞ The downloading of the Phone book or the SMS

disconnects the sound.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood KOS-A210 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood KOS-A210

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info