Bedienungsanleitung Kenwood SB270 series Smoothie (Seite 5 von 150) (Alle Sprachen)

630909

Zoom out

Zoom in

Vorherige Seite

1/150

Nächste Seite

ints

To make a thinner smoothie drink

dd more liquid.

o make a thicker smoothie drink

add more frozen ingredients but

o not exceed the frozen limit

arked on the goblet.

Before fitting the lid, push the solid

ngredients into the liquid using the

tirrer.

Use the pulse ‘P’ button to

operate the power unit in a start

stop action to control the texture

of your drink. Take care as this

automatically selects the higher

speed and may cause the drink to

be thrown up the sides and onto

the lid of the goblet.

After blending, some drinks may

not be completely smooth due to

seeds or the fibrous nature of

ingredients.

Some drinks may separate on

standing, therefore, it’s best to

drink them straight away.

Separated drinks should be stirred

before drinking.

important

Never blend more than the

maximum capacity of 1500ml

marked on the goblet.

Never blend dry ingredients (eg

spices, nuts) or run the Smoothie

Blender empty.

Don’t use the Smoothie Blender

as a storage container. Keep it

empty before and after use.

Some liquids increase in volume

and froth during blending eg milk,

so do not overfill and ensure the lid

is correctly fitted.

To ensure long life of your

Smoothie Blender, never run it

continuously for longer than 60

seconds.

Never blend food that has formed

a solid mass during freezing, break

it up before adding to the goblet.

care and cleaning

Always switch off, unplug and

dismantle before cleaning.

ever let the power unit, cord or

plug get wet.

Empty the goblet before

nscrewing the blade unit.

Always wash immediately after

use. Don’t let food dry onto the

goblet assembly as this will make

cleaning difficult.

Don’t wash any part in the

dishwasher.

Regularly dismantle the tap and

clean the parts thoroughly.

Smoothie Blender unit

Before dismantling the Smoothie

Blender, half fill the goblet with

warm water. Fit the lid and stirrer

then place on the power unit.

Switch to low ‘ ’ and whilst

running open the tap and allow the

water to drain into a container to

clean the valve. This can be

repeated until the water runs clear.

If further cleaning is necessary

dismantle the unit first.

power unit

Wipe with a damp cloth, then dry.

Push excess cord into the back of

the power unit.

blade unit

1 Remove and wash the sealing ring.

2 Don’t touch the sharp blades -

brush them clean using hot soapy

water, then rinse thoroughly under

the tap. Don’t immerse the blade

assembly in water.

3 Leave to dry upside down away

from children.

goblet, lid, cap and stirrer

Wash by hand, rinse with clean

water then dry.

cleaning the tap

Remove the tap assembly from the

goblet, then soak the tap in hot

soapy water with the valve open

. Wash thoroughly then rinse and

dry. Wash and dry the goblet then

refit the tap ensuring that the seal

is correctly positioned on the goblet

.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood SB270 series Smoothie Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info