523405
74
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
9 OPTIONAL ACCESSORY
68 CONTENTS TS-590S
Adopts a PFC Circuit that does not Produce Harmonics in an AC Rectifier Circuit
A switching power supply typically produces large harmonics in the rectifier circuit by its switching
operation which compromises the phase factor and may cause noise and other disturbances to
external devices due to the harmonics that are reflected back to the AC input side.
PS-60 incorporates a PFC-rectifier circuit that produces a rectified waveform close to a sine wave
and prevents a compromise of phase factor and disturbances caused by harmonics.
Miniaturized Size by Employing an Interleaved Switching Scheme
By turning On and Off the FET switches on the master and slave sides alternately, the burden on
each element is lessened and reliability is improved.
In the switching circuit, a full-wave current resonance type PFM control circuit is adopted to
alternately turn On and Off two FETs in a 50% duty cycle. By defining a certain period of time after
both FETs are turned Off, a soft switching operation, in which no current is made to flow at the point
of switchover, is made possible to reduce noise.
Figure 9-2 Comparing Rectification Waveforms
A high switching frequency (about 500 kHz) is chosen to enable miniaturization of the transformer for
highly-efficient DC conversion.
The DC output voltage after the conversion is monitored by the detection circuit to be compared with
the reference voltage in the PFM control circuit in order to control the switching frequency for
stabilizing the output voltage. If an overvoltage is detected, the switching of power source stops so
as to suspend the DC output.
Also, output current is monitored by the detection circuit and if an overcurrent is detected, the
switching frequency is shifted to droop the output voltage and the operation is transited to produce
intermittent output.
Figure 9-3 Circuit Diagram
9.2 Rectifier Circuit
9.3 Switching Circuit, Constant-voltage Circuit and
Protection Circuit
74

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kenwood TS-590S wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Kenwood TS-590S

Kenwood TS-590S Bedienungsanleitung - Deutsch - 92 seiten

Kenwood TS-590S Bedienungsanleitung - Holländisch - 92 seiten

Kenwood TS-590S Bedienungsanleitung - Französisch - 92 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info