Bedienungsanleitung Kenwood VRS6200 (Seite 36 von 40) (Englisch)

510822

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

In case of difficulty

÷ Press the input selector key and select the optimum control mode.

÷ Replace with new batteries.

÷ Point the remote control unit to the remote sensor of the receiver. #

÷ Connect them properly referring to "Setting up the system"

÷ The remote control has not been set to the operation mode for the KENWOOD DVD player you

wish to control. Press the DVD key to activate the operation mode for the KENWOOD DVD player

you want to control before operation. ›

Remote control operation is not

possible.

Remote control unit

Symptom Remedy

Memory back-up function

If the power supply to the receiver is shut down for about a day

or more, the following settings will be reset to the initial condi-

tions. Please be careful.

÷ Volume level =

66 dB

÷ Dimmer level = OFF (Brightest condition)

÷ Broadcast band = FM

÷ Frequency setting = 87.50 MHz

÷ Tuning mode = AUTO

÷ Listen mode setting = STEREO

÷ Input selector settings = TUNER

÷ TONE ON/OFF = OFF

÷ LOUDNESS ON/OFF = OFF

÷ BASS BOOST ON/OFF = OFF

÷ FRONT AUX mode = GAME

As an ENERGY STAR

Partner, Kenwood Corpora-

tion has determined that this products meets the

ENERGY STAR

guidelines for energy efficiency.

This product can save energy. Saving energy re-

duces air pollution and lowers utility bills.

FCC WARNING

This equipment may generate or use radio frequency energy. Changes

or modifications to this equipment may cause harmful interference

unless the modifications are expressly approved in the instruction

manual. The user could lose the authority to operate this equipment

if an unauthorized change or modification is made.

NOTE:

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment may

cause harmful interference to radio communications, if it is not

installed and used in accordance with the instructions. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

– –

Reorient or relocate the receiving antenna.

– –

Increase the separation between the equipment and receiver.

– –

Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

– –

Consult the dealer or an experienced radio / TV technician for help.

Note to CATV system installer

This reminder is provided to call the CATV system installer's attention

to Article 820-40 of the NEC that provides guidelines for proper

grounding and, in particular, specifies that the cable ground shall be

connected to the grounding system of the building, as close to the

point of cable entry as practical.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood VRS6200 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood VRS6200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info