Bedienungsanleitung Kenwood xd 8050 (Seite 2 von 76) (Englisch)

157476

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

XD-8550/XD-6000 (En/T)

Preparation sectionBasic sectionApplication sectionKnowledge sections

Before applying power

Units are designed for operation as follows.

Europe and U.K......................................................................... AC 230 V only

Factory fitted moulded mains plug

1.The mains plug contains a fuse. For replacement, use only a 13-

Amp ASTA-approved (BS1362) fuse.

2.The fuse cover must be refitted when replacing the fuse in the

moulded plug.

3.Do not cut off the mains plug from this equipment. If the plug

fitted is not suitable for the power points in your home or the cable

is too short to reach a power point, then obtain an appropriate

safety approved extension lead or adapter, or consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dis-

pose of the plug immediately, to avoid a possible shock hazard by

inadvertent connection to the mains supply.

IMPORTANT: The wires in the mains lead are coloured in accord-

ance with the following code:

Blue : Neutral

Brown : Live

Do not connect those leads to the earth terminal of a three-pin plug.

For the United Kingdom

The marking is located on the rear panel and says that the compo-

nent uses laser beams that have been classified as Class 1. It means

that the unit is utilizing laser beams that are of a weaker class. There

is no danger of hazardous radiation outside the unit.

CLASS 1

LASER PRODUCT

The marking of products using lasers

(Except for some areas)

REQUIREMENT BY NEDERLAND GAZETTE

Safety precautions

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER

(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-

FIED SERVICE PERSONNEL.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED

TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE

PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELEC-

TRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO

THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE

LITERATURE ACCOMPANYING THE APPLIANCE.

CAUTION

Batteries are supplied with this product. When

they empty, you should not throw away. Instead,

hand them in as small chemical waste.

Caution : Read this page carefully to ensure safe operation.

This instruction manual is designed for common use by two models and the combination of components of each model is shown in the

following table. As the functions of each component is variable depending on the model, please check the component models delivered to

you by referring to the following table.

DP-MH5

C-H6 A-H5 X-H5 LS-H6

C-H5 A-H5 X-H5 DP-H5 LS-H5

XD-8550

XD-6000

Tuner/

Equalizer

Amplifier Cassette deck

CD player

Speaker

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood xd 8050 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info