Bedienungsanleitung Klipsch Icon SB 1 (Seite 1 von 2) (Englisch)

584727

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Red and

Green

(alternating)

Quick Setup Guide - Programming The KLIPSCH ICON™ SB 1 To Your TV Remote

Easy, Three-Step Remote Programming

The KLIPSCH ICON™ SB 1 soundbar has four control buttons under the status indicator lights

on its front panel. From the top button down, they are SOURCE, MUTE, VOLUME UP, and VOLUME

DOWN. MUTE, VOLUME UP, AND VOLUME DOWN can easily be programmed to your TV, Satellite or

Cable box remote control so that you can use that remote to control these functions.

NOTE: The KLIPSCH ICON™ SB 1 model comes with its own remote and controls not only the

four control buttons but has a separate button for the 3D Surround Mode On/Off feature. MUTE,

VOLUME UP, AND VOLUME DOWN can be programmed into other remote controls using the built-

in Learning Remote feature, but the 3D Surround mode On/Off button cannot be learned by any

other remote and must be controlled with the included remote.

IMPORTANT NOTE: There is not a power on/off button on the front of the soundbar (there is a Main Power switch on the soundbar’s rear

panel). You do not need to turn off the soundbar (or subwoofer) when ﬁnished watching TV. When ﬁnished, turn off your TV (or Satellite or

Cable box if the soundbar is connected to that). The soundbar (and the subwoofer) will automatically go into a Standby or “sleep” mode

if they do not receive an audio signal from your TV, Satellite or Cable Box for approximately 10 minutes. Standby mode is indicated by a

solid red status light on the soundbar front and on the subwoofer rear panel. When your TV, Satellite or Cable box is turned back on and a

signal is again received, the soundbar (and subwoofer) will automatically come out of Standby mode and turn on.

STEP ONE (Place the unit in learning mode): With the status light showing solid GREEN,

press and hold the <SOURCE> and <MUTE> buttons on the front of the soundbar at the

same time (approximately 3 seconds) until the status light ﬂashes RED and GREEN.

The following 3 steps should be used to program each function of your TV or cable box

remote control buttons (MUTE, VOLUME UP, and VOLUME DOWN). IF THE SOUNDBAR IS

IN STANDBY MODE (solid RED status light), push the <SOURCE> button on the sound-

bar until the status light is solid GREEN.

STEP TWO (Select the function to learn): Press the <MUTE> button once on the soundbar

(the status light changes to solid ORANGE). (Substitute the VOLUME UP, and VOLUME DOWN

in place of <MUTE> when programming the other buttons during this step)

STEP THREE (Learn the function): Hold your remote control within one foot and pointed

at the front of the soundbar. Slowly press the <MUTE> button on your remote control

four times. On the ﬁrst three presses, the status indicator light will ﬂicker ORANGE with

each press. If the unit has successfully learned the function, on the fourth press of the

button, the light will ﬂash GREEN several times and then turn to solid GREEN. (Remem-

ber to use the VOLUME UP, and VOLUME DOWN in place of <MUTE> when program-

ming the other buttons during this step)

To program the remaining functions, simply repeat all steps, substituting <MUTE>

with the new function and button presses (VOLUME UP, and VOLUME DOWN) on steps

TWO and THREE.

STATUS LIGHTS

SOURCE

MUTE

VOLUME UP

VOLUME DOWN

Solid

Orange

1 Foot

1 2

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Klipsch Icon SB 1 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Klipsch Icon SB 1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info