Bedienungsanleitung Klipsch Icon Series X (Seite 4 von 36) (Deutsch, Englisch, Französisch, Italienisch, Spanisch)

584730

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Care and Cleaning

• Occasional dusting or wiping of the cabinet with a cloth

is all that is required. Never use abrasive or solvent type

cleaners or harsh detergents.

• A vacuum cleaner with a soft brush attachment may be used

to clean the grille fabric.

• Never spray polishes or cleaners on the drive units (woofers,

midranges or tweeters).

FCC and Canada Compliance Information

NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protec-

tion against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Approved under the veriﬁcation provision of FCC Part 15 as a Class

B Digital Device.

Caution: Changes or modiﬁcations not expressly approved by the

manufacturer could void the user’s authority to operate this device.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme á la norme

NMB-003 du Canada

EU Compliance Information

Eligible to bear the CE mark, Conforms to European Union Low Volt-

age Directive 73/23/EEC and 2006/95/EC; Conforms to European

Union EMC Directives 89/336/EEC and 2004/108/EC.

WEEE Notice

Note: This mark applies only to countries within the European Union

(EU) and Norway.

This application is labeled in accordance with

European Directive 2002/96/EC concerning waste

electrical and electronic equipment (WEEE). This label

indicates that this product should not be disposed of

with household waste. It should be deposited at an

appropriate facility to enable recovery and recycling.

Power - This switch allows you to select either “AUTO” or “ON”

for the speakers built in ampliﬁer. When “AUTO” is selected, the

speaker will automatically turn on when it senses a signal. It will

automatically turn off after 20 minutes if no signal is present. In the

“ON” setting the speaker will remain on as long as the AC power

cord is plugged into a wall socket. The power indicator LED on the

front panel will illuminate BLUE when speaker is on and RED when

the speaker is in standby. The LED will be off if the AC power cord

is not connected to an AC outlet.

Input Sensitivity - This switch adjusts the level of the input signal

to optimize the performance of the built-in ampliﬁer. See “Active

Floorstanding Connections” for more information.

Active Floorstander Controls

(See ﬁgure 5.)(XF-48 only)

Bass Management

When using your speakers in a home theater system, consult

the owner’s manual of your surround electronics for proper

application of bass management settings.

• As a general rule, compact speakers (Bookshelf, Center

Channel and Surrounds) are set to the “Small,” or bass-

limited setting.

• Floorstanding speakers are typically set to the “Large,” or

full-range setting.

• Also refer to the electronics instructions for adjusting the

relative volume levels of the speakers so they are at the same

level when in the listening position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Klipsch Icon Series X Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info