785037
24
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
TROUBLE SHOOTING
22
Please check the following guide for the possible cause and solution for a problem before contacting the
nearest service center or dealer for repairs.
To reset this unit
The following do not indicate a problem with this unit:
Regular disc rotating sounds.
Image disturbance during search.
To return all settings other
than some settings to the
factory preset
Select Yes in Restore Default Settings in the Setup menu.
This returns all values in the Setup menu and the on-screen
menu, except for parental setting to the default settings.
POWER
No power. Insert the AC power supply cord securely into a known active AC outlet.
The unit switches to standby
mode. One of the units safety devices is activated. Press [STANDBY/ON]
on the main unit to turn the unit on.
This is a power saving feature.
Operation
The remote control doesnt
work properly.
The batteries are depleted. Replace them with new ones.
You are not pointing the remote control at the main units remote control
signal sensor during operation.
Colored glass may obstruct the signal reception/transmission.
Dont place the signal sensor in direct sunlight or in areas that may be
subject to sunlight exposure.
The unit is on but cannot be
operated.
Confirm the correct drive is selected.
Some operations may be prohibited by the disc.
Reset the unit as follows:
1.Press [STANDBY/ON] on the main unit to switch the unit to standby.
If the unit doesnt switch to standby, Alternatively, disconnect the AC
power supply cord, wait one minute, then reconnect it.
2.Press [STANDBY/ON] on the main unit to switch it on. If the unit still
cannot be operated, consult the dealer.
Condensation has formed: Wait 1 to 2 hours for it to evaporate.
Play fails to start even when
(PLAY) is pressed. Play starts
but then stops immediately.
Insert the disc correctly with the label facing up.
The disc is dirty.
You tried to play a blank disc or unplayable disc on this unit.
Startup is slow.
When the unit is turned on,
audio and video output takes
a long time.
Startup takes time in the following situations.
Immediately after a power failure or the AC power supply cord is
connected.
When the unit is connected with an HDMI cable.
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kogan KABRP21WFIA wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info