508773
2
Zoom out
Zoom in
Vorherige Seite
1/3
Nächste Seite
Battery installation:
Alarm:
1. The battery compartment is accessed
from the rear of the alarm by removing the
screws of the mounting bracket.
2. Insert 4x C size batteries (not included)
according the correct polarity
(see figure C)
3. When the batteries are inserted the
alarm will beep very loud to indicate that
the batteries are properly installed.
4. Replace the mounting bracket and fix it
with the screws. The battery LED indicator
will light when the batteries are LOW and
need to be replaced.
Remote control:
The remote control uses 3x LR44 batteries (included). If the red
LED indicator on the remote control does not light up when the
‘ARM’ or ‘DISARM’ buttons are pressed, then the batteries need to
be replaced.
Program alarm:
1. Set the switches (12) of the remote control to the desired code
and remove the batteries from the alarm. Then wait at least 30
seconds for the alarm to reset.
2. Aim, immediately after inserting the batteries, the remote control
at the alarm and press the ‘ARM’ button. The Alarm LED will flash
once to indicate that it has learnt the code of the remote control.
NOTE: the alarm must be programmed again with the remote
control each time the batteries are replaced.
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Konig Electronic SEC-APC10 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Konig Electronic SEC-APC10

Konig Electronic SEC-APC10 Bedienungsanleitung - Holländisch - 3 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info