When grinding, the best results are achieved if you
work at a setting angle of approx. 20°–30°.
Disassembly/Assembly of the protection cover
If the protection cover (4) has to be removed, proceed as
follows: Unscrew the two screws (5) and remove the coun-
terflange (6). The protection cover (4), annular ring (7) and
limit stop washer (8) can now be lifted off. The pro-tection
cover (4) is assembled in the opposite order.
Cutting and grinding may only be done with the pro-tec-
tion cover on!
Adjusting the protection cover
Depending upon the use, the protection cover can be
swung back to the stop cams (9). When the assist handle
is mounted and you need to work with the swingguard,
newer swing it back on the handle side – you could other-
wise seriously injure yourself!
Mounting instructions for grinding and cutting discs
The examples show how grinding rings are to be fastened
to the spindle end with the clamping flange (10). A spindle
lock makes loosening and tightening the clamping flange
(10) with the pin-type face wrench easier. When doing this,
hold the pusher (11) pressed in.
Attention!
Actuate only during standstill!
Replacing the carbon brushes
Our service personnel will carry out this and all other servi-
cing work quickly and professionally.
Before mounting tools, disconnect the mains plug.
Mains cable
Damaged mains cables must not be used. They should be
replaced immediately at an authorised service point.
Accessories included in delivery
1 pin-type face wrench
Noise/vibration information
Measured values correspond with EN 50144.
Sound pressure level: 82,5
+3
dB (A)
Sound power level: 95,5
+3
dB (A)
Work place emission
value: 85,5
+3
dB (A)
Operators require noise protection equipment.
The acceleration measured is usually less than 2.5 m/s
2
.
Special equipment
Roughing discs for stones and non-ferrous metals
Roughing disc for steel and castings
Cutting disc for stones
Adhesive grinding disc, complete set
Adhesive fleece (K 180)
Adhesive supporting disc M 14
Vulcanized fiber discs, complete set
Supporting disc with clamping flange for vulcanized fiber
discs
Steel wire cup-shaped brush
Environmental protection
Kress takes back used machines for resource saving re-
cycling. Due to their modular construction Kress machines
can be very easily broken down into their recyclable basic
materials. Hand in your old Kress machine at a dealer or
send them directly to Kress.
Subject to change without notice.
4
3
2
