Bedienungsanleitung Kubota B2620 (Seite 86 von 88) (Englisch)

639538

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

70 STORAGE

STORAGE

To avoid personal injury:

A Do not clean the machine while the engine is

running.

A To avoid the danger of exhaust fume

poisoning, do not operate the engine in a

closed building without proper ventilation.

A When storing, remove the key from the key

switch to avoid unauthorized persons from

operating the tractor and getting injured.

TRACTOR STORAGE

If you intend to store your tractor for an extended period

of time, follow the procedures outlined below.

These procedures will insure that the tractor is ready to

operate with minimum preparation when it is removed

from storage.

1. Check the bolts and nuts for looseness, and tighten if

necessary.

2. Apply grease to tractor areas where bare metal will

rust also to pivot areas.

3. Detach the weights from the tractor body.

4. Inflate the tires to a pressure a little higher than usual.

5. Change the engine oil and run the engine to circulate

oil throughout the engine block and internal moving

parts for about five minutes.

6. Keep the clutch disengaged. If the clutch is left

engaged for a long period of time, the clutch plate may

rust, making clutch disengagement impossible at the

next operation.

7. With all implements lowered to the ground, coat any

exposed hydraulic cylinder piston rods with grease.

8. Remove the battery from the tractor. Store the battery

following the battery storage procedures.

(See "Battery" in "EVERY 100 HOURS" in "PERIODIC

SERVICE" section.)

9. Keep the tractor in a dry place where the tractor is

sheltered from the elements. Cover the tractor.

10.Store the tractor indoors in a dry area that is protected

from sunlight and excessive heat. If the tractor must be

stored outdoors, cover it with a waterproof tarpaulin.

Jack the tractor up and place blocks under the front

and rear axles so that all four tires are off the ground.

Keep the tires out of direct sunlight and extreme heat.

A When washing the tractor, be sure to stop the engine.

Allow sufficient time for the engine to cool before

washing.

A Cover the tractor after the muffler and the engine have

cooled down.

REMOVING THE TRACTOR FROM

STORAGE

1. Check the tire air pressure and inflate the tires if they

are low.

2. Jack the tractor up and remove the support blocks

from under the front and rear axles.

3. Install the battery. Before installing the battery, be sure

it is fully charged.

4. Check the fan belt tension.

5. Check all fluid levels (engine oil, transmission/

hydraulic oil, engine coolant and any attached

implements).

6. Start the engine. Observe all gauges. If all gauges are

functioning properly and reading normal, move the

tractor outside. Once outside, park the tractor and let

the engine idle for at least five minutes. Shut the

engine off and walk around tractor and make a visual

inspection looking for evidence of oil or water leaks.

7. With the engine fully warmed up, release the parking

brake and test the brakes for proper adjustment as you

move forward. Adjust the brakes as necessary.

(1) Wooden block

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kubota B2620 Seite 86

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info