17462
121
Zoom out
Zoom in
Vorherige Seite
1/146
Nächste Seite
8-1
1. Error messages
When any of the messages listed in the table below appear on the message display, take the corrective action as instructed.
“Close xxx cover x.”
“Add paper in cassette.”
“Set cassette.”
“Paper cassette is out of order. Select another
paper drawer.”
“Check paper size.”
“Reposition original.”
“Exceeds pre registered copying quantity.”
“Ready to copy. Add toner.”
“Add toner to resume copying.”
“System error.
Main switch off/on.”
“System error.
Disconnect power plug from the socket.”
“Call service.”
The cover indicated is open. Close the cover securely.
There is no paper in the drawer indicated. Load paper.
One of the drawers is not closed properly. Pull it out and push it back in all
the way.
The drawer currently in use is out of order and cannot be used. Contact
your service representative immediately. Continue copying using another
drawer.
No paper that can be used in the selected mode is loaded. Check the
paper.
The orientation of the original and the selected paper are different. Change
the orientation of the original. If the Start key is pressed, same-size copy-
ing will be performed.
The number of copies reached the limit set in the copy management
mode and no more copies can be made. Clear the copy count from the
management mode.
There is not enough toner in the copier. Replace the toner container im-
mediately as only one copy can be made at a time.
There is not enough toner in the copier to make copies. Replace the
toner container immediately.
A system error has occurred. Turn the main switch OFF and then ON.
A system error has occurred. Disconnect the power plug from the outlet
and connect it again.
Open and close the front cover. If the same message appears again,
make a note of the “C” and the number appearing with it, turn the main
switch OFF (), unplug the power cord from the outlet, and contact your
service representative.
Page
Message
Action
3-1
6-1
3-4
3-4
8-6
8-6
CHAPTER 8 WHEN A PROBLEM OCCURS
* If the optional fax kit is installed in your copier, when the power cord is unplugged from the outlet, original data or reserved communica-
tion information stored in the memory may be lost.
121

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Kyocera KM2530 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Kyocera KM2530

Kyocera KM2530 Bedienungsanleitung - Holländisch - 72 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info