Bedienungsanleitung La Crosse WS272 (Seite 2 von 2) (Englisch)

680745

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

POSITIONING THE OUTDOOR TEMPERATURE

TRANSMITTER

Before wall mounting, please check that the

outdoor temperature can be received from the

desired locations.

Mount the transmitter at a sheltered place. Avoid

direct rain and sunshine.

The transmitter is supplied with a holder that

may be attached to a wall with the two screws

supplied. The sensor can also be position on a

flat surface by securing the stand to the bottom

to the transmitter.

To wall mount:

1. Secure the bracket onto a desired wall

using the screws and plastic anchors.

2. Clip the remote temperature sensor onto

the bracket.

Note:

Before permanently fixing the transmitter wall

base, place all units in the desired locations to

check that the outdoor temperature reading is

receivable. In event that the signal is not received,

relocate the transmitters or move them slightly as this may help the

signal reception.

CARE AND MAINTENANCE:

 Extreme temperatures, vibration and shock should be avoided

as these may cause damage to the unit and give inaccurate

forecasts and readings.

 Precautions shall be taken when handling the batteries. Injuries,

burns, or property damage may be resulted if the batteries are

in contact with conducting materials, heat, corrosive materials

or explosives. The batteries shall be taken out from the unit

before the product is to be stored for a long period of time.

 Immediately remove all low powered batteries to avoid leakage

and damage. Replace only with new batteries of the

recommended type.

 When cleaning the display and casings, use a soft damp cloth

only. Do not use solvents or scouring agents as they may mark

the LCD and casings.

 Do not submerge the unit in water.

 Special care shall be taken when handling a damaged LCD

display. The liquid crystals can be harmful to user's health.

 Do not make any repair attempts to the unit. Return them to

their original point of purchase for repair by a qualified engineer.

Opening and tampering with the unit may invalidate their

guarantee.

 Never touch the exposed electronic circuit of the device as

there is a danger of electric shock should it become exposed.

 Do not expose the units to extreme and sudden temperature

changes, this may lead to rapid changes in forecasts and

readings and thereby reduce their accuracy.

SPECIFICATIONS:

Recommended temperature range:

+5ºC to +40ºC / +41ºF to 104ºF

Temperature measuring range:

Indoor : -9.5ºC to +59.5ºC with 0.1ºC resolution /

14.0ºF to +139.5ºF with 0.2ºF resolution

(OFL displayed if outside this range. In degree F

display, OFL will displayed when over 99.9ºF)

Outdoor : -9.9ºC to +59.9ºC with 0.1ºC resolution /

14.1ºF to +139.8ºF with 0.2ºF resolution

(OFL displayed if outside this range. In degree F

display, OFL will displayed when over 99.9ºF)

Relative humidity measuring range:

Indoor : 20% to 95% with 1% resolution (display “- -“ if

temperature is OFL, except when the temperature is

100ºF to 139.8ºF; display “19%” if < 20% and “96%”

if > 95%)

Equivalent CO

ppm measuring range:

450ppm to 6950ppm with 50ppm resolution (display OFL > 6950ppm)

Measuring intervals:

Indoor temperature checking interval : every 16 seconds

Indoor humidity checking interval : every 16 seconds

Outdoor temperature checking interval : every 4 seconds

Air quality level checking interval : every 3 minutes

Power consumption:

Air quality monitor : 2 x C, IEC LR14, 1.5V

Transmitter : 2 x AA, IEC LR6, 1.5V

Battery life : up to 12 months

Dimensions (L x W x H):

Air quality monitor : 112.6 x 49.5 x 112.4mm

Transmitter : 38.2 x 21.2 x 128.3 mm

LIABILITY DISCLAIMER:

 The electrical and electronic wastes contain hazardous

substances. Disposal of electronic waste in wild country and/or

in unauthorized grounds strongly damages the environment.

 Please contact your local or/and regional authorities to retrieve

the addresses of legal dumping grounds with selective

collection.

 All electronic instruments must from now on be recycled. User

shall take an active part in the reuse, recycling and recovery of

the electrical and electronic waste.

 The unrestricted disposal of electronic waste may do harm on

public health and the quality of environment.

 As stated on the gift box and labeled on the product, reading

the “User manual” is highly recommended for the benefit of the

user. This product must however not be thrown in general

rubbish collection points.

 The manufacturer and supplier cannot accept any responsibility

for any incorrect readings and any consequences that occur

should an inaccurate reading take place.

 This product is designed for use in the home only as indication

of the temperature and other weather data.

 This product is not to be used for medical purposes or for

public information.

The specifications of this product may change without prior

notice.

 This product is not a toy. Keep out of the reach of children.

No part of this manual may be reproduced without written

authorization of the manufacturer.

R&TTE Directive 1999/5/EC

Summary of the Declaration of

Conformity : We hereby declare

that this wireless transmission

device does comply with the

essential requirements of R&TTE

Directive 1999/5/EC.

La Crosse WS272 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info