SETTING UP:
1. Insert the 2 x AA, IEC LR6, 1.5V batteries into the transmitter (See “To install and replace
batteries in the Temperature Transmitter” above).
2. Within 2 minutes, insert 2 x AA, IEC LR6, 1.5V batteries into the Weather wall clock as
indicated above (see "To install and replace batteries in the Weather wall clock“ above).
3. Once the batteries are in place, all segments of the LCD will light up briefly and a brief bip
sound will be hear. Then the indoor and outdoor temperature - -.-°C, the time as 0:00, the date
as 1/1, and weekday will be displayed.
4. Do not press any buttons for 10 minutes
5. The Weather wall clock will start receiving data from the transmitter. The remote temperature
will then be displayed on the Weather wall clock. If the outdoor temperature is not displayed 60
seconds after inserting the batteries into the receiver, all batteries are needed to be removed
and wait for at least 1 minute for reset from step 1.
6. The DCF time code reception will automatically start. This takes typically between 3 - 5 minutes
in good conditions. This time period is an excellent opportunity to locate the transmitter in
suitable location outdoors. In order to ensure sufficient 868MHz transmission however, this
should under good conditions be no more than 100 meters from where the Weather wall clock
will be finally positioned (see notes on “Positioning” and “868MHz Reception”).
7. If after 10 minutes the DCF time has not been received, use the SET key to manually enter the
set mode and change either the time or date in order to activate the DCF reception. The clock
will then automatically attempt to receive the DCF time every full hour each day. When this is
successful, the received time will override the manually set time. The date is also updated with
the received time (Please refers to notes on “DCF Radio controlled time” and “Manual time
setting”).
8. The indoor temperature will be measured after the DCF reception.
Note:
In the event of changing batteries of the unit ensure that the batteries do not spring free from the
contacts. Always wait at least 1 minute after removing the batteries before reinserting, otherwise start
up and transmission problems may occur.
FUNCTION KEYS
The weather wall clock has four easy to use keys:
SET key : To enter into the set mode for the following functions: L time zone, language,
manual time setting, year, month, day, weekday, and ºC or ºF temperature display
+ key : To toggle between the weekday/date, alarm time, or second display
To change the values in manual set mode
19