Bedienungsanleitung La Crosse WS9057 (Seite 13 von 15) (Englisch)

606456

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

Outdoor

temperature

3. To reset the minimum and maximum temperature and humidity data, and the times at which they were recorded, press the

SET key continuously for about 3 seconds. This will reset the MIN/MAX data recorded to the current time, date, temperature

and humidity. The current time taken is the normal displayed time and does not regard the time zone set for the unit.

Note: the MIN/MAX data for each transmitter needs to be reset separately.

ABOUT THE OUTDOOR TRANSMITTER:

The LCD display shows the current temperature and humidity at the location of the transmitter. The temperature and humidity is

measured and transmitted to the Weather Station approximately every 4 seconds.

The range of the transmitter may be affected by the temperature and humidity. At cold temperatures the transmitting distance may

be decreased. Please bear this in mind when positioning the transmitter. The LCD contrast on the unit will also be reduced when the

batteries are reduced in power.

LOW BATTERY INDICATOR

Low battery indicator is displayed on the LCD when the batteries require changing.

CHECKING FOR 868MHz RECEPTION

If the outdoor temperature and humidity data are not being received within three minutes after setting up (or outdoor display always

show “- -. -” in the outdoor section of the Weather station during normal operation), please check the following points:

1. The distance of the Weather station or transmitters should be at least 2 meters away from any interfering sources such as

computer monitors or TV sets.

2. Avoid placing the transmitters onto or in the immediate proximity of metal window frames.

3. Using other electrical products such as headphones or speakers operating on the 868MHz-signal frequency may prevent

correct signal transmission or reception. Neighbors using electrical devices operating on the 868MHz-signal frequency can

also cause interference.

Note:

When the 868MHz signal is received correctly, do not re-open the battery cover of either the transmitter or Weather station, as the

batteries may spring free from the contacts and force a false reset. Should this happen accidentally then reset all units (see “Setting

up” above) otherwise transmission problems may occur.

The transmission range is around 100 meters from the Thermo-hygro transmitter to the Weather station (in open space). However,

this depends on the surrounding environment and interference levels. If no reception is possible despite the observation of these

factors, all system units have to be reset (see “Setting up” above).

POSITIONING THE WEATHER STATION

The Weather station provides the option of table standing or wall mounting the unit. Before wall mounting, please check that the

outdoor data can be received from the desired locations.

To wall mount:

1. Fix a screw (not supplied) into the desired wall, leaving the head extended out by about 5mm.

2. Place the weather station onto the screw, using the hanging hole on the backside. Gently pull

the weather station down to lock the screw into place.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

La Crosse WS9057 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info