7
Using your steam mop
1. Sweep or vacuum your floors before using your steam mop.
2. Pull and twist the quick release cord holder to unwrap the power cord completely. Plug in
and the “On” button will flash blue. If your light doesn’t turn on, turn to the Troubleshooting
section, page 8.
3. It takes about 30 seconds for the steam to be ready for use. Press the “On” button to activate
the steam. The indicator light will then go from a flashing blue to a solid blue light.
4. Once you have finished using the steam mop, press the “On” button again to stop steam being
released.
Back Saver Function
1. Use the back saver function to access tight areas. Press the release button on the handle to bend
and lock the steam mop in the back saver position.
2. To place the handle back into the upright position, press the release button and pull upwards to
straighten the handle.
Carpet Glider Accessory
The carpet glider can be used for light sanitation on your carpets.
1. Sweep or vacuum your floors before using your steam mop on your carpet.
2. To use the carpet glider, place the mop with pad attached in to the glider. Use the steam mop in
the usual way.
3. Once you have finished using the carpet glider, lift the mop out of the glider and continue to use
on hard floors if required, otherwise switch the unit off and unplug.
Microfibre pads
Washing instructions:-
• Machinewashableupto40˚C
• Useliquiddetergentonly
• Donotbleachorusefabricsoftener
• Washseparatelyfromotherfabrics
• Airdryortumbledryonalowsetting
If there are loose threads on the pad carefully cut the thread with scissors. Do not pull on
them or cut at the base.
To order replacement pads, call the helpline on 015394 88100
3 replacement microfibre pads ref: 23308
