Bedienungsanleitung Lanaform LA120602 (Seite 7 von 80) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch)

719419

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

Living

In timer mode:

- Start by selecting a colour that corresponds to the level of vapour emission required.

- Press the on/o button for 3 seconds, a beeping sound will be heard and the light will  ash with the colour selected.

It will automatically go on for 2 hours.

- If you wish to turn the timer o , just press the on/o button again for 3 seconds, a beeping sound will be heard and the light will stop  ashing.

Remote control (before using it, please remove the plastic strip on the battery)

You can also control the device using its remote control (Scheme 2):

- Press the button

to start, select one of the four dispersion modes (consul the table above for more features) and stop the device.

- Press the button

to turn the timer on or o for 2 hours.

9) When the water reservoir is empty, the safety system will stop the device automatically.

10) Switch o the “LIVING” essential oils humidi er and di user and unplug it.

IMPORTANT NOTES:

- Do not pour hot water above 40°C into the reservoir.

- Only use distilled or demineralised water to avoid any malfunction.

- To avoid any malfunction and  re risk, do not pour water into the sprinkler tip (point at which the cold mist comes out of the device).

- Make sure the reservoir lid is tightly closed after  lling so as to avoid leakage or potential electric shocks.

- The reservoir must be kept clean. If the nozzle emitting cold mist is dirty, clean it with a brush or damp cloth.

Please note: EVEN THOUGH THERE IS A SAFETY DEVICE THAT STOPS THE TRANSDUCER WORKING, DO NOT LEAVE THE DEVICE CONNECTED WHEN YOU ARE NOT USING IT.

Press the on/o button Light Cold mist level

Press once Orange Low

Press twice Green Medium

Press 3 times Blue High

Press 4 times Red Low (night mode/timer: 5 hours)

“Humidi er” mode

Just select the emission intensity you require.

“Essential oils di user” mode

You will need to remove the top of the device (j), the di user sprinkler tip (i) and the aroma ring (g). Then pour a few drops (3 to 4 drops at

most) of essential oils onto the essential oils foam tab contained in this aroma ring (h). Finally, replace the ring on the top of the device (f)

(g) and put the sprinkler tip back into position (i). Your essential oils di user is now ready for operation and will disperse a pleasant scent (j).

8) Press the on/o button (Scheme 1, item 11) and the device will start to work.

You can either use the device in continuous mode or programme it with a timer.

In continuous mode:

Press the on/o button to adjust the cold-mist level, the light will change colour and a beeping sound will be heard.

See chart below for further options:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Lanaform LA120602 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info