Bedienungsanleitung Land Rover Range Rover - 2000 (Seite 47 von 48) (Englisch)

626352

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Cleaning & vehicle care

177

WASHING YOUR VEHICLE

Wash your car frequently using a sponge and

generous quantities of cold or lukewarm water

containing a car shampoo. Rinse and dry off

with a chamois leather.

• Do not use hot water!

• Do not use detergent soap products or

dishwashing liquid!

When using a hose, do not direct the jet into

the heater air intake ducts, or through the

wheel trim apertures onto the brake

components, or at the door, window or

sunroof seals, where water pressure could

penetrate the seals.

WARNING

Some high pressure cleaning systems are

sufficiently powerful to penetrate door and

window seals and damage rubbing strips

and locking mechanisms. Never aim the

water jet directly at components that might

easily be damaged.

Underbody maintenance

Corrosive materials used for snow and ice

removal and dust control can collect on

underbody parts. If these materials are not

removed, accelerated rusting can occur on

underbody parts such as the frame, floor pan

and the exhaust system. Regularly flush these

materials from the underbody with plain

water. Take care to thoroughly clean any areas

where mud and other debris can collect.

Similarly, after off-road driving or wading in

muddy or salt water conditions, use a hose to

wash underbody components and other

exposed parts of the vehicle.

Steam cleaning

Before steam cleaning the engine

compartment, cover the power steering and

brake fluid reservoirs to prevent

contamination of fluid. After steam cleaning

carefully re-wax the metallic components,

especially the steering column, engine coolant

pipes, hose clips and the ignition coil clamp.

Removing tar spots

Use mineral spirit or turpentine to remove tar

spots and stubborn grease stains from the

paintwork. Then wash immediately with soapy

water to remove all traces of spirit.

Body protection

After washing, inspect the paintwork for

damage. Any stone chips, fractures or deep

scratches in the body work should be repaired

promptly. Bare metal will corrode quickly and

can develop into major repair expense. Some

exterior panels of your vehicle are made of

aluminum which will not corrode in the same

manner as sheet steel. However, any damage

should still receive prompt attention. Minor

chips and scratches can be repaired with

touch-up materials available from your dealer.

Larger areas of damage need to be corrected

to professional standards immediately.

Occasionally protect the paint surface with an

application of car polish.

NOTE: DO NOT apply car polish to the

moulded bumpers - polish will become

ingrained in the textured finish of the

mouldings.

Cast alloy road wheels

The cast alloy road wheels are covered with a

protective coating. To prevent corrosion, it is

essential that this coating is not damaged. To

clean the wheels, use a warm soapy liquid,

stubborn stains can be removed using a soft

brush.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Land Rover Range Rover - 2000 Seite 47

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info