495520
11
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
EN
19
SOLUTIONS FOR COMMON PROBLEMS
TECHNICAL CHARACTERISTICS
· Power supply: : 220-240 V / 50-60 Hz
· Nominal power: 1000 W
· Water tank capacity: 1800 cc
· Weight: 8,7 kg
· Materials used for the body: ABS
·
Size: Height 36,5 cm - Width 27,5 cm - Depth 29,0 cm
For the technical characteristics, refer to the data plate on the machine.
2006/42 CE – 2004/108 CE – 2006 /95 CE
For problems not covered in the above table or if the suggested solutions do not solve the problems, contact
the Lavazza customer service.
Problem Possible causes Solutions
The machine does not turn on. » Machine not connected to the
mains.
» Check the correct jack input.
The LEDs fl ash quickly.
» There is a failure. » Contact the customer service or the service
centre.
The capsule loading arm does not
reach the locking position.
» The used capsule drawer/drip
tray is full.
» Capsule inserted incorrectly.
» Empty the used capsule drawer/drip tray.
» Lift the capsule loading arm and insert cor-
rectly the capsule.
The pump does not start.
» No water in the tank. » Fill with fresh drinking water and repeat the
loading of the hydraulic circuit.
The machine does not brew coff ee.
» Capsule not inserted.
» Operating temperature not
reached.
» Capsule loading arm lifted.
» No water in the tank.
» Filter not correctly inserted.
» Insert the capsule.
» Wait until it reaches the proper temperature.
» Lower the capsule loading arm.
» Fill with fresh drinking water and repeat the
loading of the hydraulic circuit.
» Check the insertion of the Brita®
lter and
repeat the loading of the hydraulic circuit
(see instructions provided with the fi lter).
The coff ee is not hot enough.
» The coff ee cups are cold.
» A large amount of hot water was
dispensed.
» Preheat the coff ee cups by dispensing hot
water.
» Wait at least 20 seconds after dispensing
hot water.
The coff ee fl ows too quickly, no
cream forming for the espresso.
» An already used capsule was
introduced.
» Insert a new capsule.
No milk or cappuccino froth.
» The milk is not good.
» The milk is not cold enough.
» Steam dispensing wand clogged.
» Use fresh, partially skimmed milk.
» Use milk at refrigerator temperature.
» Clean the steam wand with a needle and
clean the spout.
No hot water or steam dispensing.
» Steam/hot water spout clogged.
» No water in the tank.
» Filter not correctly inserted.
» Clean the spout (see maintenance and
cleaning). If the problem persists, clean
the hole of the dispensing unit with a fi ne
needle, making sure it s not clogged, then
turn on the machine and dispense a small
amount of steam.
» Fill with fresh drinking water and repeat the
loading of the hydraulic circuit.
» Check the insertion of the Brita®
lter and
repeat the loading of the hydraulic circuit
(see instructions provided with the fi lter).
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Lavazza LB 1100 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info